#
# For a description of the syntax of this configuration file,
# see the file kconfig-language.txt in the NuttX tools repository.
#

config EXAMPLES_FLOWC
	tristate "Serial flow control example"
	default n
	depends on SERIAL_TERMIOS
	---help---
		Enable the serial hardware flow control test.

		Serial termios support must be enabled.

			CONFIG_SERIAL_TERMIOS=y

		In addition, you will need these related serial driver settings (the
		actual values of the watermark setting may be tuned to suit your
		preferences)

			CONFIG_SERIAL_IFLOWCONTROL=y
			CONFIG_SERIAL_IFLOWCONTROL_WATERMARKS=y
			CONFIG_SERIAL_IFLOWCONTROL_LOWER_WATERMARK=25
			CONFIG_SERIAL_IFLOWCONTROL_UPPER_WATERMARK=75

		And for the CDC/ACM driver in particular:

			CONFIG_CDCACM_IFLOWCONTROL=y

		There are hooks in place for output flow control but these have not
		been exercised.

if EXAMPLES_FLOWC

config EXAMPLES_FLOWC_INPUT
	bool "Verify input flow control"
	default y
#	depends on SERIAL_IFLOWCONTROL

config EXAMPLES_FLOWC_OUTPUT
	bool "Verify output flow control"
	default y
#	depends on SERIAL_OFLOWCONTROL

config EXAMPLES_FLOWC_SENDER1
	bool "Target1 is the sender"
	default n
	---help---
		By default Target1 is the receiver and the host PC (or Target2) is
		the sender.  That is the configuration you would to test RX flow
		control on the target.

config EXAMPLES_FLOWC_PROGNAME1
	string "Target1 program name"
	default "flowc" if !EXAMPLES_FLOWC_TARGET2
	default "flowc1" if EXAMPLES_FLOWC_TARGET2
	---help---
		This is the name of the Target1 program that will be used when the
		NSH ELF program is installed.

config EXAMPLES_FLOWC_PRIORITY1
	int "Target1 task priority"
	default 100

config EXAMPLES_FLOWC_STACKSIZE1
	int "Target1 stack size"
	default DEFAULT_TASK_STACKSIZE

config EXAMPLES_FLOWC_TARGET2
	bool "Second endpoint is a target"
	default n
	---help---
		By default, the host PC is configured as the second endpoint of the
		FLOWC test.  If this option is selected, then the second endpoint
		will be built into the FLASH image as well.  This means that you
		can use two target boards to run the test with no host PC
		involvement.

if EXAMPLES_FLOWC_TARGET2

config EXAMPLES_FLOWC_PROGNAME2
	string "Target2 program name"
	default "flowc2"
	---help---
		This is the name of the Target2 program that will be used when the
		NSH ELF program is installed.

config EXAMPLES_FLOWC_PRIORITY2
	int "Target2 task priority"
	default 100

config EXAMPLES_FLOWC_STACKSIZE2
	int "Target2 stack size"
	default DEFAULT_TASK_STACKSIZE

endif # EXAMPLES_FLOWC_TARGET2

config EXAMPLES_FLOWC_RECEIVER_BUFSIZE
	int "Receiver buffer size"
	default 64

config EXAMPLES_FLOWC_RECEIVER_DELAY
	int "Receiver read delay (msec)"
	default 100

config EXAMPLES_FLOWC_RECEVER_DEVNAME
	string "Default TTY device for receiver"
	default "/dev/ttyACM0"

config EXAMPLES_FLOWC_SENDER_DEVNAME
	string "Default TTY device for sender"
	default "/dev/ttyACM0"

endif # EXAMPLES_FLOWC