44 lines
1.8 KiB
Plaintext
Executable File
44 lines
1.8 KiB
Plaintext
Executable File
system/cdcacm
|
|
^^^^^^^^^^^^^^^
|
|
|
|
This very simple add-on allows the USB CDC/ACM serial device can be dynamically
|
|
connected and disconnected from a host. This add-on can only be used as
|
|
an NSH built-in command. If built-in, then two new NSH commands will be
|
|
supported:
|
|
|
|
1. sercon - Connect the CDC/ACM serial device
|
|
2. serdis - Disconnect the CDC/ACM serial device
|
|
|
|
Configuration prequisites (not complete):
|
|
|
|
CONFIG_USBDEV=y : USB device support must be enabled
|
|
CONFIG_CDCACM=y : The CDC/ACM driver must be built
|
|
CONFIG_NSH_BUILTIN_APPS : NSH built-in application support must be enabled
|
|
|
|
Configuration options specific to this add-on:
|
|
|
|
CONFIG_SYSTEM_CDCACM_DEVMINOR : The minor number of the CDC/ACM device.
|
|
: i.e., the 'x' in /dev/ttyACMx
|
|
|
|
If CONFIG_USBDEV_TRACE is enabled (or CONFIG_DEBUG and CONFIG_DEBUG_USB, or
|
|
CONFIG_USBDEV_TRACE), then the add-on code will also initialize the USB trace
|
|
output. The amount of trace output can be controlled using:
|
|
|
|
CONFIG_SYSTEM_CDCACM_TRACEINIT
|
|
Show initialization events
|
|
CONFIG_SYSTEM_CDCACM_TRACECLASS
|
|
Show class driver events
|
|
CONFIG_SYSTEM_CDCACM_TRACETRANSFERS
|
|
Show data transfer events
|
|
CONFIG_SYSTEM_CDCACM_TRACECONTROLLER
|
|
Show controller events
|
|
CONFIG_SYSTEM_CDCACM_TRACEINTERRUPTS
|
|
Show interrupt-related events.
|
|
|
|
Note: This add-on is only enables or disable USB CDC/ACM via the NSH
|
|
'sercon' and 'serdis' command. It will enable and disable tracing per
|
|
the settings before enabling and after disabling the CDC/ACM device. It
|
|
will not, however, monitor buffered trace data in the interim. If
|
|
CONFIG_USBDEV_TRACE is defined (and the debug options are not), other
|
|
application logic will need to monitor the buffered trace data.
|