nuttx/Documentation/components/net/slip.rst

====
SLIP
====

SLIP Configuration
==================

#. Configure and build NuttX with SLIP enabled in the configuration. Load this
   into FLASH and start the device.

#. Connect to a Linux box using a serial cable. This dicussion assumes that the
   serial device is ``/dev/ttyS0`` on both the target and the Linux box.

#. Reset on the target side and attach SLIP on the Linux side:

   .. code-block:: bash

      $ modprobe slip
      $ slattach -L -p slip -s 57600 /dev/ttyS0 &

   This should create an interface with a name like sl0, or sl1, etc. Add -d to
   get debug output. This will show the interface name.

   NOTE: The -L option is included to suppress use of hardware flow control.
   This is necessary only if you are not supporting hardware flow control on
   the target.

   NOTE: The Linux slip module hard-codes its MTU size to 296. So you might
   as well set ``CONFIG_NET_ETH_MTU`` to 296 as well.

#. After turning over the line to the SLIP driver, you must configure the
   network interface. Again, you do this using the standard ifconfig and
   route commands. Assume that we have connected to a host PC with address
   192.168.0.101 from your target with address 10.0.0.2. On the Linux PC
   you would execute the following as root (assuming the SLIP is attached
   to device sl0):

   .. code-block:: bash

      $ ifconfig sl0 10.0.0.1 pointopoint 10.0.0.2 up
      $ route add 10.0.0.2 dev sl0

#. For monitoring/debugging traffic:

   .. code-block:: bash

      $ tcpdump -n -nn -i sl0 -x -X -s 1500

   NOTE: If hardware handshake is not available, then you might try the
   slattach option-L which is supposed to enable "3-wire operation."