2022-07-22 10:29:40 +02:00
|
|
|
/****************************************************************************
|
|
|
|
|
* boards/arm/s32k3xx/s32k344evb/include/board.h
|
|
|
|
|
*
|
|
|
|
|
* Licensed to the Apache Software Foundation (ASF) under one or more
|
|
|
|
|
* contributor license agreements. See the NOTICE file distributed with
|
|
|
|
|
* this work for additional information regarding copyright ownership. The
|
|
|
|
|
* ASF licenses this file to you under the Apache License, Version 2.0 (the
|
|
|
|
|
* "License"); you may not use this file except in compliance with the
|
|
|
|
|
* License. You may obtain a copy of the License at
|
|
|
|
|
*
|
|
|
|
|
* http://www.apache.org/licenses/LICENSE-2.0
|
|
|
|
|
*
|
|
|
|
|
* Unless required by applicable law or agreed to in writing, software
|
|
|
|
|
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
|
|
|
|
|
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
|
|
|
|
|
* License for the specific language governing permissions and limitations
|
|
|
|
|
* under the License.
|
|
|
|
|
*
|
|
|
|
|
****************************************************************************/
|
|
|
|
|
|
|
|
|
|
/* Copyright 2022 NXP */
|
|
|
|
|
|
|
|
|
|
#ifndef __BOARDS_ARM_S32K3XX_S32K344EVB_INCLUDE_BOARD_H
|
|
|
|
|
#define __BOARDS_ARM_S32K3XX_S32K344EVB_INCLUDE_BOARD_H
|
|
|
|
|
|
|
|
|
|
/****************************************************************************
|
|
|
|
|
* Included Files
|
|
|
|
|
****************************************************************************/
|
|
|
|
|
|
|
|
|
|
#include <nuttx/config.h>
|
|
|
|
|
|
|
|
|
|
/****************************************************************************
|
|
|
|
|
* Pre-processor Definitions
|
|
|
|
|
****************************************************************************/
|
|
|
|
|
|
|
|
|
|
/* Clocking *****************************************************************/
|
|
|
|
|
|
|
|
|
|
/* The S32K344EVB is fitted with a 16 MHz crystal */
|
|
|
|
|
|
|
|
|
|
#define BOARD_XTAL_FREQUENCY 16000000
|
|
|
|
|
|
|
|
|
|
/* The S32K344 will run at 160 MHz */
|
|
|
|
|
|
|
|
|
|
/* LED definitions **********************************************************/
|
|
|
|
|
|
|
|
|
|
/* The S32K344EVB has two RGB LEDs:
|
|
|
|
|
*
|
|
|
|
|
* RedLED0 PTA29 (EMIOS1 CH12 / EMIOS2 CH12)
|
|
|
|
|
* GreenLED0 PTA30 (EMIOS1 CH13 / EMIOS2 CH13)
|
|
|
|
|
* BlueLED0 PTA31 (EMIOS1 CH14 / FXIO D0)
|
|
|
|
|
*
|
|
|
|
|
* RedLED1 PTB18 (EMIOS1 CH15 / EMIOS2 CH14 / FXIO D1)
|
|
|
|
|
* GreenLED1 PTB25 (EMIOS1 CH21 / EMIOS2 CH21 / FXIO D6)
|
|
|
|
|
* BlueLED1 PTE12 (EMIOS1 CH5 / FXIO D8)
|
|
|
|
|
*
|
|
|
|
|
* If CONFIG_ARCH_LEDS is not defined, then the user can control the LEDs in
|
|
|
|
|
* any way. The following definitions are used to access individual RGB
|
|
|
|
|
* components.
|
|
|
|
|
*
|
|
|
|
|
* The RGB components could, alternatively be controlled through PWM using
|
|
|
|
|
* the common RGB LED driver.
|
|
|
|
|
*/
|
|
|
|
|
|
|
|
|
|
/* LED index values for use with board_userled() */
|
|
|
|
|
|
|
|
|
|
#define BOARD_LED0_R 0
|
|
|
|
|
#define BOARD_LED0_G 1
|
|
|
|
|
#define BOARD_LED0_B 2
|
|
|
|
|
|
|
|
|
|
#define BOARD_LED1_R 3
|
|
|
|
|
#define BOARD_LED1_G 4
|
|
|
|
|
#define BOARD_LED1_B 5
|
|
|
|
|
|
|
|
|
|
#define BOARD_NLEDS 6
|
|
|
|
|
|
|
|
|
|
/* LED bits for use with board_userled_all() */
|
|
|
|
|
|
|
|
|
|
#define BOARD_LED0_R_BIT (1 << BOARD_LED0_R)
|
|
|
|
|
#define BOARD_LED0_G_BIT (1 << BOARD_LED0_G)
|
|
|
|
|
#define BOARD_LED0_B_BIT (1 << BOARD_LED0_B)
|
|
|
|
|
|
|
|
|
|
#define BOARD_LED1_R_BIT (1 << BOARD_LED1_R)
|
|
|
|
|
#define BOARD_LED1_G_BIT (1 << BOARD_LED1_G)
|
|
|
|
|
#define BOARD_LED1_B_BIT (1 << BOARD_LED1_B)
|
|
|
|
|
|
|
|
|
|
/* If CONFIG_ARCH_LEDs is defined, then NuttX will control the LEDs on board
|
|
|
|
|
* the S32K344EVB. The following definitions describe how NuttX controls the
|
|
|
|
|
* LEDs:
|
|
|
|
|
*
|
|
|
|
|
* SYMBOL Meaning LED state
|
|
|
|
|
* RED GREEN BLUE
|
|
|
|
|
* ---------------- ----------------------------- -------------------
|
|
|
|
|
*/
|
|
|
|
|
|
|
|
|
|
#define LED_STARTED 1 /* NuttX has been started OFF OFF OFF */
|
|
|
|
|
#define LED_HEAPALLOCATE 2 /* Heap has been allocated OFF OFF ON */
|
|
|
|
|
#define LED_IRQSENABLED 0 /* Interrupts enabled OFF OFF ON */
|
|
|
|
|
#define LED_STACKCREATED 3 /* Idle stack created OFF ON OFF */
|
|
|
|
|
#define LED_INIRQ 0 /* In an interrupt (No change) */
|
|
|
|
|
#define LED_SIGNAL 0 /* In a signal handler (No change) */
|
|
|
|
|
#define LED_ASSERTION 0 /* An assertion failed (No change) */
|
|
|
|
|
#define LED_PANIC 4 /* The system has crashed FLASH OFF OFF */
|
|
|
|
|
#undef LED_IDLE /* S32K344 is in sleep mode (Not used) */
|
|
|
|
|
|
|
|
|
|
/* Button definitions *******************************************************/
|
|
|
|
|
|
|
|
|
|
/* The S32K344EVB supports two buttons:
|
|
|
|
|
*
|
|
|
|
|
* SW0 PTB26 (EIRQ13 / WKPU41)
|
|
|
|
|
* SW1 PTB19 (WKPU38)
|
|
|
|
|
*/
|
|
|
|
|
|
|
|
|
|
#define BUTTON_SW0 0
|
|
|
|
|
#define BUTTON_SW1 1
|
|
|
|
|
#define NUM_BUTTONS 2
|
|
|
|
|
|
|
|
|
|
#define BUTTON_SW0_BIT (1 << BUTTON_SW0)
|
|
|
|
|
#define BUTTON_SW1_BIT (1 << BUTTON_SW1)
|
|
|
|
|
|
|
|
|
|
/* UART selections **********************************************************/
|
|
|
|
|
|
|
|
|
|
/* By default, the serial console will be provided on the OpenSDA VCOM port:
|
|
|
|
|
*
|
|
|
|
|
* OpenSDA UART RX PTA15 (LPUART6_RX)
|
|
|
|
|
* OpenSDA UART TX PTA16 (LPUART6_TX)
|
|
|
|
|
*/
|
|
|
|
|
|
|
|
|
|
#define PIN_LPUART6_RX PIN_LPUART6_RX_1 /* PTA15 */
|
|
|
|
|
#define PIN_LPUART6_TX PIN_LPUART6_TX_1 /* PTA16 */
|
|
|
|
|
|
|
|
|
|
/* LPUART13 J58 USB-UART */
|
|
|
|
|
|
|
|
|
|
#define PIN_LPUART13_RX PIN_LPUART13_RX_2 /* PTC27 */
|
|
|
|
|
#define PIN_LPUART13_TX PIN_LPUART13_TX_2 /* PTC26 */
|
|
|
|
|
|
|
|
|
|
/* SPI selections ***********************************************************/
|
|
|
|
|
|
|
|
|
|
/* LPSPI0 FS26 Safety SBC */
|
|
|
|
|
|
|
|
|
|
#define PIN_LPSPI0_SCK PIN_LPSPI0_SCK_1 /* PTC8 */
|
|
|
|
|
#define PIN_LPSPI0_MISO PIN_LPSPI0_SIN_1 /* PTC9 */
|
|
|
|
|
#define PIN_LPSPI0_MOSI PIN_LPSPI0_SOUT_2 /* PTB1 */
|
|
|
|
|
|
|
|
|
|
#define PIN_LPSPI0_PCS (PIN_PTB0 | GPIO_LOWDRIVE | GPIO_OUTPUT_ONE) /* PTB0 */
|
|
|
|
|
|
|
|
|
|
/* LPSPI1 J353 Arduino Header */
|
|
|
|
|
|
|
|
|
|
#define PIN_LPSPI1_SCK PIN_LPSPI1_SCK_4 /* PTB14 */
|
|
|
|
|
#define PIN_LPSPI1_MISO PIN_LPSPI1_SIN_4 /* PTB15 */
|
|
|
|
|
#define PIN_LPSPI1_MOSI PIN_LPSPI1_SOUT_3 /* PTB16 */
|
|
|
|
|
|
|
|
|
|
#define PIN_LPSPI1_PCS PIN_LPSPI1_PCS3_2 /* PTB17 */
|
|
|
|
|
|
|
|
|
|
/* I2C selections ***********************************************************/
|
|
|
|
|
|
|
|
|
|
/* LPI2C1 J353 Arduino Header / J63 ENET PHY / MMA8452Q Accelerometer
|
|
|
|
|
* / SGTL5000 Audio Codec
|
|
|
|
|
*/
|
|
|
|
|
|
|
|
|
|
#define PIN_LPI2C1_SCL PIN_LPI2C1_SCL_1 /* PTC7 */
|
|
|
|
|
#define PIN_LPI2C1_SDA PIN_LPI2C1_SDA_1 /* PTC6 */
|
|
|
|
|
|
|
|
|
|
/* FLEXCAN selections *******************************************************/
|
|
|
|
|
|
|
|
|
|
#define PIN_CAN0_TX PIN_CAN0_TX_1 /* PTA7 */
|
|
|
|
|
#define PIN_CAN0_RX PIN_CAN0_RX_1 /* PTA6 */
|
|
|
|
|
|
2023-12-14 15:22:07 +01:00
|
|
|
#endif /* __BOARDS_ARM_S32K3XX_S32K344EVB_INCLUDE_BOARD_H */
|
