nuttx/boards/z80/ez80/z20x/include/board.h

92 lines
3.1 KiB
C
Raw Normal View History

/****************************************************************************
* boards/z80/ez80/z20x/include/board.h
*
* Licensed to the Apache Software Foundation (ASF) under one or more
* contributor license agreements. See the NOTICE file distributed with
* this work for additional information regarding copyright ownership. The
* ASF licenses this file to you under the Apache License, Version 2.0 (the
* "License"); you may not use this file except in compliance with the
* License. You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
* License for the specific language governing permissions and limitations
* under the License.
*
****************************************************************************/
#ifndef __BOARDS_Z80_EZ80_Z20X_INCLUDE_BOARD_H
#define __BOARDS_Z80_EZ80_Z20X_INCLUDE_BOARD_H
/****************************************************************************
* Included Files
****************************************************************************/
#include <stdint.h>
/****************************************************************************
* Pre-processor Definitions
****************************************************************************/
/* Clocking
*
* The z20x CPU board has a 20Mhz crystal. The eZ80F92 has no PLL; the
* system clock frequency is equal to the crystal frequency of 20MHz, the
* maximum for the eZ80F92 part.
*/
#define EZ80_SYS_CLK_FREQ 20000000
/* LEDs */
/* The D3 GREEN LED is driven by an eZ80 GPI/O pin. However, it has some
* additional properties:
*
* 1. On input, it will be '1' if the I/O expansion board is present.
* 2. Setting it to an output of '0' will generate a system reset.
* 3. Setting it to an output of '1' will not only illuminate the LED
* take the card out of reset and enable power to the SD card slot.
*
* As a consequence, the GREEN LED will not be illuminated if SD card
* support or SPI is disabled. The only effect of CONFIG_ARCH_LEDS is that
* the GREEN LED will turned off in the event of a crash.
*/
#define LED_STARTED 0
#define LED_HEAPALLOCATE 0
#define LED_IRQSENABLED 0
#define LED_STACKCREATED 0
#define LED_IDLE 0
#define LED_INIRQ 0
#define LED_ASSERTION 0
#define LED_SIGNAL 0
#define LED_PANIC 1
/* Button definitions
* The z20x CPU board has no on-board buttons that can be sensed by the
* eZ80.
*/
/****************************************************************************
* Public Functions Definitions
****************************************************************************/
#undef EXTERN
#if defined(__cplusplus)
#define EXTERN extern "C"
extern "C"
{
#else
#define EXTERN extern
#endif
#undef EXTERN
#if defined(__cplusplus)
}
#endif
#endif /* __BOARDS_Z80_EZ80_Z20X_INCLUDE_BOARD_H */