diff --git a/ChangeLog b/ChangeLog index ed82daf1dc..7a58276972 100755 --- a/ChangeLog +++ b/ChangeLog @@ -10014,6 +10014,6 @@ have extended memory regions, and (3) devices that use 8-bit addressing (2015-03-17). * arch/mips/src/mips32/Kconfig, Toolchain.defs, and - configs/pic32mz-starterkit/nsh/Make.defs: Change that will permit + configs/pic32mz-starterkit/nsh/Make.defs: Changes that will permit building of the PIC32MZ Start Kit configuration using MPLAB and the XC32 toolchain. From David Sidrane (2015-03-17). diff --git a/configs/samv71-xult/README.txt b/configs/samv71-xult/README.txt index f8046f01ac..9843890858 100644 --- a/configs/samv71-xult/README.txt +++ b/configs/samv71-xult/README.txt @@ -362,8 +362,9 @@ Connectivity: I2C address: - The 7-bit address of the AT24 part is is 0b1011AAA where AAA is the state - of the A0, A1, and A3 pins on the part. On the SAMV71-XULT board, these + The 7-bit addresses of the AT24 part are 0b1010AAA for the normal 2Kbit + memory and 0b1011aaa for the "extended memory" where aaa is the state of + the A0, A1, and A3 pins on the part. On the SAMV71-XULT board, these are all pulled high so the full, 7-bit address is 0x5f. Networking @@ -859,11 +860,11 @@ Configuration sub-directories 70: -- -- -- -- -- -- -- -- nsh> - Where 0x1a us the address of the WM8904 Audio CODEC and 0x5f is the - address of the AT24 EEPROM (I am not sure what the others are as - this writing). - - CAREFUL!!! You can trash your MAC address using the I2C tool! + Where 0x1a us the address of the WM8904 Audio CODEC, 0x28 is the + address of TWI interface to the EDBG, 0x4e is the address of the + CP2100CP programmable PLL, and 0x57 and 0x5f are the addresses of + the AT2 EEPROM (I am not sure what the other address, 0x37, is are + as this writing). 7. Support for HSMCI is built-in by default. The SAMV71-XULT provides one full-size SD memory card slot. Refer to the section entitled