From 67ffe7974cfc42c4368bc1b58ca3b2918e0ea66f Mon Sep 17 00:00:00 2001 From: Nonpawit Ekburanawat Date: Tue, 17 Sep 2024 21:08:35 +0200 Subject: [PATCH] doc: Add STM32H745I-DISCO RPTUN documentation Signed-off-by: Nonpawit Ekburanawat --- .../stm32h7/boards/stm32h745i-disco/index.rst | 34 ++++++++++++++++--- 1 file changed, 30 insertions(+), 4 deletions(-) diff --git a/Documentation/platforms/arm/stm32h7/boards/stm32h745i-disco/index.rst b/Documentation/platforms/arm/stm32h7/boards/stm32h745i-disco/index.rst index ca103ecf94..18d73a2f61 100644 --- a/Documentation/platforms/arm/stm32h7/boards/stm32h745i-disco/index.rst +++ b/Documentation/platforms/arm/stm32h7/boards/stm32h745i-disco/index.rst @@ -3,9 +3,13 @@ ST STM32H745I-DISCO =================== Dual core support ------------------ +================= It is recommended to use CMake to build firmware consisting of multiple images. + +Dual instances +-------------- + The commands to build ``nsh_xxx`` configurations are as follows:: cmake -B build_cm7 -DBOARD_CONFIG=stm32h745i-disco:nsh_cm7 -GNinja @@ -14,8 +18,19 @@ The commands to build ``nsh_xxx`` configurations are as follows:: cmake --build build_cm7 cmake --build build_cm4 +Dual core RPTun +--------------- + +The commands to build ``nsh_xxx_rptun`` configurations are as follows:: + + cmake -B build_cm7_rptun -DBOARD_CONFIG=stm32h745i-disco:nsh_cm7_rptun -GNinja + cmake -B build_cm4_rptun -DBOARD_CONFIG=stm32h745i-disco:nsh_cm4_rptun -GNinja + + cmake --build build_cm7_rptun + cmake --build build_cm4_rptun + Serial console --------------- +============== The STM32H745I-DISCO board's ST-LINK interface is connected to USART3, which is used as the serial console for the Cortex-M7 core by default. The @@ -28,7 +43,8 @@ USART3_RX PB11 USART3_TX PB10 ================= ==== -When using the nsh_xxx configuration, UART7 is assigned to the Cortex-M4 core. +When using the ``nsh_xxx`` configuration, UART7 is assigned to the Cortex-M4 +core. The UART7 connections can be accessed via the Arduino connector on the board: ================= ================= @@ -40,4 +56,14 @@ UART7_TX PB4 (Arduino D5) This allows the Cortex-M4 core to utilize a separate serial interface, making it possible to debug or interact with both cores simultaneously through -different UART interfaces. \ No newline at end of file +different UART interfaces. + +RPTun +----- + +When using the ``nsh_xxx_rptun`` configuration, users can connect to the +CM4 core from the CM7 core by using the ``cu`` command:: + + nsh-cm7> cu -l /dev/ttyproxy + NuttShell (NSH) NuttX-10.4.0 + nsh-cm4>