sergiotarxz/nuttx
1
0
Fork 0
Code Issues Pull Requests Releases Wiki Activity

arch/arm/src/stm32h7/stm32_ethernet.c: Break long lines to pass style checks

Browse Source 
Signed-off-by: Jukka Laitinen <jukka.laitinen@intel.com>
This commit is contained in:
Jukka Laitinen 2020-05-13 14:15:03 +03:00 committed by patacongo
parent d618dad296
commit db492ca03b
1 changed files with 64 additions and 36 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

100
arch/arm/src/stm32h7/stm32_ethernet.c
View File

@ -333,7 +333,8 @@
* ETH_MACCR_BL Back-off limit 0 (10)
* ETH_MACCR_ACS Automatic pad/CRC stripping 0 (disabled)
* ETH_MACCR_DR Retry disable 1 (disabled)
* ETH_MACCR_IPC IPv4 checksum offload Depends on CONFIG_STM32H7_ETH_HWCHECKSUM
* ETH_MACCR_IPC IPv4 checksum offload
* Depends on CONFIG_STM32H7_ETH_HWCHECKSUM
* ETH_MACCR_LM Loopback mode 0 (disabled)
* ETH_MACCR_DO Receive own disable 0 (enabled)
* ETH_MACCR_DCRS Carrier sense disable 0 (enabled)
@ -356,9 +357,9 @@
(ETH_MACCR_BL_10 | ETH_MACCR_DR | ETH_MACCR_IPG(96))
#endif
/* Clear the MACPFR bits that will be setup during MAC initialization (or that
* are cleared unconditionally). Per the reference manual, all reserved bits
* must be retained at their reset value.
/* Clear the MACPFR bits that will be setup during MAC initialization (or
* that are cleared unconditionally). Per the reference manual, all reserved
* bits must be retained at their reset value.
*
* ETH_MACPFR_PR Bit 0: Promiscuous mode
* ETH_MACPFR_HUC Bit 1: Hash unicast
@ -385,15 +386,20 @@
/* The following bits are set or left zero unconditionally in all modes.
*
* ETH_MACPFR_PR Promiscuous mode 0 (disabled)
* ETH_MACPFR_HUC Hash unicast 0 (perfect dest filtering)
* ETH_MACPFR_HMC Hash multicast 0 (perfect dest filtering)
* ETH_MACPFR_HUC Hash unicast 0 (perfect
* dest filtering)
* ETH_MACPFR_HMC Hash multicast 0 (perfect
* dest filtering)
* ETH_MACPFR_DAIF Destination address inverse filtering 0 (normal)
* ETH_MACPFR_PM Pass all multicast 0 (Depends on HMC bit)
* ETH_MACPFR_PM Pass all multicast 0 (Depends on HMC
* bit)
* ETH_MACPFR_DBF Broadcast frames disable 0 (enabled)
* ETH_MACPFR_PCF Pass control frames 1 (block all but PAUSE)
* ETH_MACPFR_PCF Pass control frames 1 (block all but
* PAUSE)
* ETH_MACPFR_SAIF Source address inverse filtering 0 (not used)
* ETH_MACPFR_SAF Source address filter 0 (disabled)
* ETH_MACPFR_HPF Hash or perfect filter 0 (Only matching frames passed)
* ETH_MACPFR_HPF Hash or perfect filter 0 (Only matching
* frames passed)
* ETH_MACPFR_RA Receive all 0 (disabled)
*/
@ -423,21 +429,27 @@
/* The following bits are set or left zero unconditionally in all modes.
*
* ETH_MACQTXFCR_FCB_BPA Flow control busy/back pressure activate 0 (no pause control frame)
* ETH_MACQTXFCR_TFE Transmit flow control enable 0 (disabled)
* ETH_MACQTXFCR_PLT Pause low threshold 0 (pause time - 4)
* ETH_MACQTXFCR_DZPQ Zero-quanta pause disable 1 (disabled)
* ETH_MACQTXFCR_FCB_BPA Flow control busy/back pressure activate 0
* (no pause control frame)
* ETH_MACQTXFCR_TFE Transmit flow control enable 0
* (disabled)
* ETH_MACQTXFCR_PLT Pause low threshold 0
* (pause time - 4)
* ETH_MACQTXFCR_DZPQ Zero-quanta pause disable 1
* (disabled)
* ETH_MACQTXFCR_PT Pause time 0
* ETH_MACRXFCR_RFE Receive flow control enable 0 (disabled)
* ETH_MACRXFCR_UP Unicast pause frame detect 0 (disabled)
* ETH_MACRXFCR_RFE Receive flow control enable 0
* (disabled)
* ETH_MACRXFCR_UP Unicast pause frame detect 0
* (disabled)
*/
#define MACQTXFCR_SET_MASK (ETH_MACQTXFCR_PLT_M4 | ETH_MACQTXFCR_DZPQ)
#define MACRXFCR_SET_MASK (0)
/* Clear the MTLTXQOMR bits that will be setup during MAC initialization (or that
* are cleared unconditionally). Per the reference manual, all reserved bits
* must be retained at their reset value.
/* Clear the MTLTXQOMR bits that will be setup during MAC initialization
* (or that are cleared unconditionally). Per the reference manual, all
* reserved bits must be retained at their reset value.
* ETH_MTLTXQOMR_FTQ Bit 0: Flush Transmit Queue
* ETH_MTLTXQOMR_TSF Bit 1: Transmit Store and Forward
* ETH_MTLTXQOMR_TXQEN Bits 2-3: Transmit Queue Enable
@ -450,18 +462,20 @@
ETH_MTLTXQOMR_TXQEN_MASK | ETH_MTLTXQOMR_TTC_MASK | \
ETH_MTLTXQOMR_TQS_MASK)
/* Clear the MTLRXQOMR bits that will be setup during MAC initialization (or that
* are cleared unconditionally). Per the reference manual, all reserved bits
* must be retained at their reset value.
/* Clear the MTLRXQOMR bits that will be setup during MAC initialization
* (or that are cleared unconditionally). Per the reference manual, all
* reserved bits must be retained at their reset value.
*
* ETH_MTLRXQOMR_RTC_MASK Bits 0-1: Receive Queue Threshold Control
* ETH_MTLRXQOMR_FUP Bit 3: Forward Undersized Good Packets
* ETH_MTLRXQOMR_FEP Bit 4: Forward Error Packets
* ETH_MTLRXQOMR_RSF Bit 5: Receive Queue Store and Forward
* ETH_MTLRXQOMR_DIS_TCP_EF Bit 6: Disable Dropping of TCP/IP Checksum Error Packets
* ETH_MTLRXQOMR_DIS_TCP_EF Bit 6: Disable Dropping of TCP/IP Checksum Error
* Packets
* ETH_MTLRXQOMR_EHFC Bit 7: Enable Hardware Flow Control
* ETH_MTLRXQOMR_RFA_MASK Bits 8-10: Threshold for Activating Flow Control
* ETH_MTLRXQOMR_RFD_MASK Bits 14-16: Threshold for Deactivating Flow Control
* ETH_MTLRXQOMR_RFD_MASK Bits 14-16: Threshold for Deactivating Flow
* Control
* ETH_MTLRXQOMR_RQS_MASK Bits 20-22: Receive Queue Size
*/
@ -1767,7 +1781,8 @@ static int stm32_recvframe(struct stm32_ethmac_s *priv)
*/
up_clean_dcache((uintptr_t)rxcurr,
(uintptr_t)rxdesc + sizeof(struct eth_desc_s));
(uintptr_t)rxdesc +
sizeof(struct eth_desc_s));
/* Remember where we should re-start scanning and reset the
* segment scanning logic
@ -1862,7 +1877,9 @@ static void stm32_receive(struct stm32_ethmac_s *priv)
while (stm32_recvframe(priv) == OK)
{
#ifdef CONFIG_NET_PKT
/* When packet sockets are enabled, feed the frame into the packet tap */
/* When packet sockets are enabled, feed the frame into the packet
* tap
*/
pkt_input(&priv->dev);
#endif
@ -2110,7 +2127,8 @@ static void stm32_freeframe(struct stm32_ethmac_s *priv)
/* Force re-reading of the TX descriptor for physical memory */
up_invalidate_dcache((uintptr_t)txdesc,
(uintptr_t)txdesc + sizeof(struct eth_desc_s));
(uintptr_t)txdesc +
sizeof(struct eth_desc_s));
}
/* We get here if (1) there are still frames "in-flight". Remember
@ -3171,7 +3189,9 @@ static int stm32_phyread(uint16_t phydevaddr, uint16_t phyregaddr,
volatile uint32_t timeout;
uint32_t regval;
/* Configure the MACMDIOAR register, preserving CSR Clock Range CR[3:0] bits */
/* Configure the MACMDIOAR register, preserving CSR Clock Range CR[3:0]
* bits
*/
regval = stm32_getreg(STM32_ETH_MACMDIOAR);
regval &= ETH_MACMDIOAR_CR_MASK;
@ -3230,7 +3250,9 @@ static int stm32_phywrite(uint16_t phydevaddr, uint16_t phyregaddr,
uint32_t regval;
uint16_t value;
/* Configure the MACMDIOAR register, preserving CSR Clock Range CR[3:0] bits */
/* Configure the MACMDIOAR register, preserving CSR Clock Range CR[3:0]
* bits
*/
regval = stm32_getreg(STM32_ETH_MACMDIOAR);
regval &= ETH_MACMDIOAR_CR_MASK;
@ -3279,8 +3301,8 @@ static int stm32_phywrite(uint16_t phydevaddr, uint16_t phyregaddr,
}
}
ninfo("MII transfer timed out: phydevaddr: %04x phyregaddr: %04x value: %04x\n",
phydevaddr, phyregaddr, value);
ninfo("MII transfer timed out: phydevaddr: %04x phyregaddr: %04x value: "
"%04x\n", phydevaddr, phyregaddr, value);
return -ETIMEDOUT;
}
@ -3320,7 +3342,9 @@ static inline int stm32_dm9161(struct stm32_ethmac_s *priv)
return ret;
}
/* If we failed to read the PHY ID1 register, the reset the MCU to recover */
/* If we failed to read the PHY ID1 register, the reset the MCU to
* recover
*/
else if (phyval == 0xffff)
{
@ -3329,7 +3353,9 @@ static inline int stm32_dm9161(struct stm32_ethmac_s *priv)
ninfo("PHY ID1: 0x%04X\n", phyval);
/* Now check the "DAVICOM Specified Configuration Register (DSCR)", Register 16 */
/* Now check the "DAVICOM Specified Configuration Register (DSCR)",
* Register 16
*/
ret = stm32_phyread(CONFIG_STM32H7_PHYADDR, 16, &phyval);
if (ret < 0)
@ -3418,7 +3444,7 @@ static int stm32_phyinit(struct stm32_ethmac_s *priv)
priv->mbps100 = 0;
priv->fduplex = 0;
/* Setup up PHY clocking by setting the CR field in the MACMDIOAR register */
/* Setup up PHY clocking by setting the CR field in the MACMDIOAR reg */
regval = stm32_getreg(STM32_ETH_MACMDIOAR);
regval &= ~ETH_MACMDIOAR_CR_MASK;
@ -3580,7 +3606,8 @@ static int stm32_phyinit(struct stm32_ethmac_s *priv)
*/
#else
if ((phyval & CONFIG_STM32H7_PHYSR_MODE) == CONFIG_STM32H7_PHYSR_FULLDUPLEX)
if ((phyval & CONFIG_STM32H7_PHYSR_MODE) ==
CONFIG_STM32H7_PHYSR_FULLDUPLEX)
{
priv->fduplex = 1;
}
@ -4342,7 +4369,8 @@ static inline int stm32_ethinitialize(int intf)
#ifdef CONFIG_NETDEV_PHY_IOCTL
priv->dev.d_ioctl = stm32_ioctl; /* Support PHY ioctl() calls */
#endif
priv->dev.d_private = (void *)g_stm32ethmac; /* Used to recover private state from dev */
priv->dev.d_private =
(void *)g_stm32ethmac; /* Used to recover private state */
priv->intf = intf; /* Remember the interface number */
/* Create a watchdog for timing polling for and timing of transmissions */
@ -4389,7 +4417,7 @@ static inline int stm32_ethinitialize(int intf)
*
* Description:
* This is the "standard" network initialization logic called from the
* low-level initialization logic in arm_initialize.c. If STM32H7_NETHERNET
* low-level initialization logic in arm_initialize.c. If STM32H7_NETHERNET
* greater than one, then board specific logic will have to supply a
* version of arm_netinitialize() that calls stm32_ethinitialize() with
* the appropriate interface number.