Make sure the user L1 page is updated to system memory when the kernel
mappings are copied.
Also, flush the I-cache when switching address environments.
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
According to rfc1112, section 7.2:
"An ICMP error message (Destination Unreachable, Time Exceeded, Parameter Problem, Source Quench, or Redirect) is
never generated in response to a datagram destined to an IP host group."
Signed-off-by: zhangshuai39 <zhangshuai39@xiaomi.com>
The libmad and libmp3lame libraries have been ported to
apps/audioutils and will be compiled with NuttX.
Signed-off-by: shizhenghui <shizhenghui@xiaomi.com>
This enables CMake based build for sim:ostest. Flags which
are set by set_source_files_properties are not reflected in
final build. Changing these to target_compile_options makes
CMake build runnable.
Signed-off-by: Daniel Jasinski <jasinskidaniel95szcz@gmail.com>
Add new driver frameworks: force feedback for vibrator, like linux,
unify vendor vibrator driver using.
Incorporating a force feedback-based driving framework to replace the
conventional driver/motor setup for controlling vibrators not only
enhances the precision and responsiveness of the haptic feedback but
also aligns better with the advancements in Linux-based driver systems.
refs docs link: https://www.kernel.org/doc/html/v4.19/input/ff.html
Signed-off-by: dongjiuzhu1 <dongjiuzhu1@xiaomi.com>
1. Should check the vmid in ivshmem_remove() when release irq instead
check the ivdev->reg;
2. Add vmid check in ivshmem_probe() because ivshmem driver only support
vmid == 0 or 1 for now in NuttX;
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
Add common ivshmem driver, provide the ivshmem bus mechisam, so
many ivshmem based driver can change to pci_ivshmem based
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
Rptun is a rptun fremework driver base on the Inter-Virtual Machine
Share Memory Device.
With this driver, two NuttX runs in different QEMU can communicate
with each other by the rpmsg api.
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
We can see them in ifconfig:
ap> ifconfig
wlan0 Link encap:Ethernet HWaddr 42:64:7f:b3:12:03 at UP mtu 1500
inet addr:10.0.1.2 DRaddr:10.0.1.1 Mask:255.255.255.0
inet6 DRaddr: ::
RX: Received Fragment Errors Bytes
00000b9b 00000000 00000000 21daf5
IPv4 IPv6 ARP Dropped
00000a33 00000137 00000031 00000000
TX: Queued Sent Errors Timeouts Bytes
00000ac4 00000ac4 00000000 00000000 1a2103
Total Errors: 00000000
Signed-off-by: meijian <meijian@xiaomi.com>
Coredump need call the block read/write ops in interrupt
Not consider the ops called in thread and intterupt simultaneously.
Only used for coredump now.
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
SO_SNDBUF takes effect only after the connection in STREAM mode
is successful
support full life cycle modification of SO_RCVBUF
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
because if priv->rx_length is zero , need to call SPIS_CTRLR_QPOLL to
receive new data from lower half and update priv->rx_length.
This reverts commit 6cb649ecf6.
