by renaming riscv_dispatch_syscall to sys_callx, so the caller
don't need the immediate step(syscallx->riscv_dispatch_syscall)
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
This implements initial support for kernel build (address environments,
page allocator) for RISC-V.
This is done a bit differently compared to the ARMV7 implementation:
- Support implemented for Sv39 MMU, however the implementation should be
extensible for other MMU types also.
- Instead of preserving and moving the L1 references around, a canonical
approach is used instead, where the page table base address register
is switched upon context switch.
- To preserve a bit of memory, only a single L1/L2 table is supported,
this gives access to 1GiB of virtual memory for each process, which
should be more than enough.
Some things worth noting:
- Assumes page pool is mapped with vaddr=paddr mappings
- The CONFIG_ARCH_XXXX_VBASE and CONFIG_ARCH_XXXX_NPAGES values are
ignored, with the exception of CONFIG_ARCH_DATA_VBASE which is used
for ARCH_DATA_RESERVE
- ARCH_DATA_RESERVE is placed at the beginning of the userspace task's
address environment
IRQ_NSTACKS, ARCH_CPU_COUNT, CONFIG_SMP_NCPUS all relate to each
other. However, a bit of clean up can be done and everything can
be merged into SMP_NCPUS.
The MPFS bootloader case works also as it requires only 1 IRQ stack
for the hart that executes as bootloader.
ESP32C3 use customized irq encoding so it's hard to share further code
with other risc-v based chips, in this patch, we keep the exception
number definition with risc-v spec.
Signed-off-by: Huang Qi <huangqi3@xiaomi.com>
- Add config "ARCH_USE_S_MODE" which controls whether the kernel
runs in M-mode or S-mode
- Add more MSTATUS and most of the SSTATUS register definitions
- Add more MIP flags for interrupt delegation
- Add handling of interrupts from S-mode
- Add handling of FPU from S-mode
- Add new context handling functions that are not dependent on the trap
handlers / ecall
NOTE: S-mode requires a companion SW (SBI) which is not yet implemented,
thus S-mode is not usable as is, yet.
They are not really defined and used in any where:
uint32_t up_getmisa(void);
uint32_t up_getarchid(void);
uint32_t up_getimpid(void);
uint32_t up_getvendorid(void);
uint32_t up_gethartid(void);
Signed-off-by: Huang Qi <huangqi3@xiaomi.com>
- Add test for mode support, which is architecture dependent
- Add tests for address alignment and region size
- Add option to query for access rights
- The function goes through every PMP entry and tests if an address
range from [base, base+size] has been configured for desired
access rights.
- If several PMP entries match the range and access rights, the
information is combined
- End result is either no access, a partial match was found, or a full
match was found. Details about the partial match are not provided.
The intent for testing access rights and not just blindly applying them
is a case where they are already set in e.g. a bootloader. In this
case, nothing should be done, unless the configuration does not match,
in which case the software must not continue further.
It can provide better auto complete experience for modern code editor,
since they use clang/gcc based parser to analyze code but lacks some
target dependent info such as __LP64__ for riscv64.
Signed-off-by: Huang Qi <huangqi3@xiaomi.com>
