Summary:
- SP_SECTION was introduced to allocate spinlock in non-cachable
region mainly for Cortex-A to stabilize the NuttX SMP kernel
- However, all spinlocks are now allocated in cachable area and
works without any problems
- So SP_SECTION should be removed to simplify the kernel code
Impact:
- None
Testing:
- Build test only
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- The CONFIG_SMP_IDLETHREAD_STACKSIZE was introduced to optimize
the idle stack size for other than CPU0
- However, there are no big differences between the idle stacks.
- This commit removes the config to simplify the kernel code
Impact:
- All SMP configurations
Testing:
- Tested with ostest with the following configs
- spresense:smp, spresense:rndis_smp
- esp32-devkitc:smp (QEMU), maix-bit:smp (QEMU)
- sabre-6quad:smp (QEMU), sabre-6quad:netnsh_smp (QEMU)
- raspberrypi-pico:smp, sim:smp (x86_64)
Signed-off-by: Masayuki Ishikawa <asayuki.Ishikawa@jp.sony.com>
This config is only useful when there is a > 4MB PSRAM and thus needs to
be selected by the user explicitly.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
arch: Allocate the space from the beginning in up_stack_frame
and modify the affected portion:
1.Correct the stack dump and check
2.Allocate tls_info_s by up_stack_frame too
3.Move the stack fork allocation from arch to sched
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
I've seen a module with 16 bytes .rodata alignment for xmm operations.
It was getting SEGV on sim/Linux because of the alignment issue.
The same module binary seems working fine after applying this patch.
Also, tested on sim/macOS and esp32 on qemu,
using a module with an artificially large alignment. (64 bytes)
Some ESP32 GPIO pins (2, 4, 12, 13, 25, 27, 32) weren't accepting
pull-up/pull-down resistors. These pins are RTC GPIO pins and need
to have pull-up/pull-down configured in the RTC registers.
Co-authored-by: Gustavo Henrique Nihei <gustavo.nihei@espressif.com>
All supported arch uses a push-down stack:
The stack grows toward lower addresses in memory. The stack pointer
register points to the lowest, valid working address (the "top" of
the stack). Items on the stack are referenced as positive(include zero)
word offsets from sp.
Which means that for stack in the [begin, begin + size):
1.The initial SP point to begin + size
2.push equals sub and then store
3.pop equals load and then add
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
Espressif Systems has submitted the SGA and we can migrate the licenses
to Apache.
Gregory Nutt has submitted the SGA and we can migrate the licenses
to Apache.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Previously SPI interrupts were enabled on DMA initialization. But since
the addition of SPI Mixed mode it created a side-effect, breaking
polling transfers. So now interrupts are enabled before the DMA
transactions and disabled once they are finished.
Furthermore, the transaction done flag is also cleared before a new
transaction starts.
Commit 6382b2ba introduced the possibility of using SPI in Mixed mode,
i.e. performing SPI transfers via both polling and interrupts. However,
setbits was only applying the configuration if DMA was not enabled.
is enabled.
That region is technically part of the PRO CPU and we should be able to
allocate it early. However, QEMU uses a slightly different bootloader
image that uses the same part for both CPU. So, when APP CPU starts
during the SMP bring up it will corrupt some data.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
In case CONFIG_MM_REGIONS doesn't include all the available memory
regions the user will have a warning to increase it.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Internal heap was occupying the region straight after .data up to
HEAP_REGION1. The issue with this is if static allocation is large,
we'll end up with too little memory left for the internal heap.
Moving it to the beginning of region 2 gives us more room to play with.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Bug description:
CONFIG_SMP=y
Suppose we have 2 cores in SMP, here is the ps return:
PID GROUP CPU PRI POLICY TYPE NPX STATE STACK USED FILLED COMMAND
0 0 0 0 FIFO Kthread N-- Assigned 004076 000748 18.3% CPU0 IDLE
1 0 1 0 FIFO Kthread N-- Running 004096 000540 13.1% CPU1 IDLE
nsh> kill -4 0
or:
nsh> kill -4 1
system blocked.
Reason:
In func xx_sigdeliver() restore stage, when saved_irqcount == 0, that means
rtcb NOT in critical_section before switch to xx_sigdeliver(), then we need
reset the critical_section state before swith back.
Fix:
Add condition to cover saved_irqcount == 0.
Change-Id: I4af7f95e47f6d78a4094c3757d39b01ac9d533b3
Signed-off-by: ligd <liguiding1@xiaomi.com>
This seems to fix esp32_readdata_encrypted() with spiram "buffer".
Note: I'm not sure if this is the right fix or not.
I couldn't find any documentation about Cache_Flush.
You can find them used in the ROM version of memcpy.
While it might be controversial if it's a good idea to use the ROM version
of these functions, it's nicer to support more instructions here anyway.
Summary:
- This commit fixes a compile warning if CONFIG_ARCH_INTERRUPTSTACK is set
Impact:
- None
Testing:
- Built with esp32-devkitc:smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- Recently I noticed that ESP32-DevKitC-32D suddenly stops
during receiving ping packets from PC after 10-20mins
- Actually, sometimes memory leak happened when some device
sent a big broadcast packet periodically on the network
- This commit fixes this issue by calling esp_wifi_free_eb()
in the case that the packet exceeds WLAN_BUF_SIZE.
- Also, this commit applies the same logic in the case that
the Wi-Fi interface is down
Impact:
- None
Testing:
- Tested with esp32-devkitc:wapi
Suggested-by: YAMAMOTO Takashi <yamamoto@midokura.com>
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- This commit changes spinlock APIs (spin_lock_irqsave/spin_unlock_irqrestore)
- In the previous implementation, the global spinlock (i.e. g_irq_spin) was used.
- This commit allows to use caller specific spinlock but also supports to use
g_irq_spin for backword compatibility (In this case, NULL must be specified)
Impact:
- None
Testing:
- Tested with the following configurations
- spresnse:wifi, spresense:wifi_smp
- esp32-devkitc:smp (QEMU), sabre6-quad:smp (QEMU)
- maxi-bit:smp (QEMU), sim:smp
- stm32f4discovery:wifi
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
The static memory is now divided at almost the middle to not override
the ROM data. The old 0x28000 will take all of what's left for heap
region1.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Summary:
- This commit fixes compile errors in esp32_spiflash.c and
esp32_wifi_adapter.c with CONFIG_SMP=y
Impact:
- SMP only
Testing:
- Tested with esp32-devkitc:wapi
- NOTE: the following configs need to be added.
+CONFIG_SMP=y
+CONFIG_SMP_IDLETHREAD_STACKSIZE=3072
+CONFIG_SMP_NCPUS=2
+CONFIG_SPINLOCK_IRQ=y
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
SMP was broken because the ROM memory wasn't set correctly. Some
regions were shared with the ROM code.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Requiring the size to be a multiple of 3 is a very strange restriction.
It doesn't even work with the default value of SPI_SLAVE_BUFSIZE.
I guess it was a typo.
The original assertion was wrong because:
* cpuint numbers for edge interrupts are not dense
(while ESP32_CPUINT_NEDGEPERIPHS is 4, EPS32_CPUINT_EDGESET is not 0xf.)
* This function is used for level interrupts too
1. when sending a message in a group fails, exit immediately
2. when catch I2C error interrupt, close interrupt
3. clear clock configuration when deinit I2C
4. free I2C interrupt when deinit I2C
wget is missing from some system (like macOS and Windows native),
it's better to use curl to simplify build environment.
Signed-off-by: Huang Qi <huangqi3@xiaomi.com>
Summary:
- During repeating ostest with sabre-6quad:smp (QEMU),
I noticed that pthread_rwlock_test sometimes stops
- Finally, I found that nxtask_exit() released a critical
section too early before context switching which resulted in
selecting inappropriate TCB
- This commit fixes this issue by moving nxsched_resume_scheduler()
from nxtask_exit() to up_exit() and also removing
spin_setbit() and spin_clrbit() from nxtask_exit()
because the caller holds a critical section
- To be consistent with non-SMP cases, the above changes
were done for all CPU architectures
Impact:
- This commit affects all CPU architectures regardless of SMP
Testing:
- Tested with ostest with the following configs
- sabre-6quad:smp (QEMU, dev board), sabre-6quad:nsh (QEMU)
- spresense:wifi_smp
- sim:smp, sim:ostest
- maix-bit:smp (QEMU)
- esp32-devkitc:smp (QEMU)
- lc823450-xgevk:rndis
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Fix the following error:
CC: chip/esp32_wifi_adapter.c
In file included from /Users/yamamoto/git/nuttx/nuttx/include/nuttx/mm/shm.h:45,
from /Users/yamamoto/git/nuttx/nuttx/include/nuttx/sched.h:42,
from /Users/yamamoto/git/nuttx/nuttx/include/sched.h:35,
from /Users/yamamoto/git/nuttx/nuttx/include/stdio.h:48,
from chip/esp32_wifi_adapter.c:28:
chip/esp32_wifi_adapter.c: In function 'phy_printf':
chip/esp32_wifi_adapter.c:3952:10: error: expected ')' before 'format'
wlinfo(format, arg);
^~~~~~
Summary:
- This commit fixes global IRQ control logic
- In previous implementation, g_cpu_irqset for a remote CPU was
set in sched_add_readytorun(), sched_remove_readytorun() and
up_schedule_sigaction()
- In this implementation, they are removed.
- Instead, in the pause handler, call enter_critical_setion()
which will call up_cpu_paused() then acquire g_cpu_irqlock
- So if a new task with irqcount > 1 restarts on the remote CPU,
the CPU will only hold a critical section. Thus, the issue such as
'POSSIBLE FOR TWO CPUs TO HOLD A CRITICAL SECTION' could be resolved.
- Fix nxsched_resume_scheduler() so that it does not call spin_clrbit()
if a CPU does not hold a g_cpu_irqset
- Fix nxtask_exit() so that it acquires g_cpu_irqlock
- Update TODO
Impact:
- All SMP implementations
Testing:
- Tested with smp, ostest with the following configurations
- Tested with spresense:wifi_smp (NCPUS=2,4)
- Tested with sabre-6quad:smp (QEMU, dev board)
- Tested with maix-bit:smp (QEMU)
- Tested with esp32-core:smp (QEMU)
- Tested with lc823450-xgevk:rndis
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- Apply the same logic added to cxd56_cpupause.c
Impact:
- SMP only
Testing:
- Tested with esp32-core:smp (QEMU)
- Run smp and ostest
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
