The stm32f412 was not a clean port. This is one step to fix
it. The shortcuts taken has caused more wasted hours finding
bad pin mappings then doing the job correctlry to begin with.
stm32:Kconfig Add CAN2 on STM32F412
SMP was broken because the ROM memory wasn't set correctly. Some
regions were shared with the ROM code.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Requiring the size to be a multiple of 3 is a very strange restriction.
It doesn't even work with the default value of SPI_SLAVE_BUFSIZE.
I guess it was a typo.
The original assertion was wrong because:
* cpuint numbers for edge interrupts are not dense
(while ESP32_CPUINT_NEDGEPERIPHS is 4, EPS32_CPUINT_EDGESET is not 0xf.)
* This function is used for level interrupts too
This bug made certain values of DRIVE setting
to be wrongly applied (which can be dangerous
under certain situations since for example H0D1
was mapped to H0H1).
Summary:
- Because this_task() and nxsched_get_tcb() are protected inside the funtcions
- Also, enter_critical_section() is used in nxsched_set_affinity()
Impact:
- No impact
Testing:
- Tested with spresense:wifi_smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
1. when sending a message in a group fails, exit immediately
2. when catch I2C error interrupt, close interrupt
3. clear clock configuration when deinit I2C
4. free I2C interrupt when deinit I2C
Summary:
- During stress test with spresense:wifi (non-SMP), I noticed
sometimes ASSERT() happened in _read_data_len()
- Actually, up_udelay(50) has been added to avoid the ASSERT
- However, I finally noticed that it should be moved before
calling dready()
- Also, I cofirmed that we can reduced the time from 50 to 30
- NOTE: we need at least 15us in my experience
Impact:
- gs2200m.c only
Testing:
- Tested with following configurations
- spresense:wifi, spresense:wifi_smp, stm32f4discovery:wifi
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
This checks if the required function is defined (when stack coloration
is enabled) and, if so, calls it to get used stack. Otherwise it just
reports zero used stack.
add support to attach the devices via HCI TTY to Bluetooth Host
Reference:
drivers/wireless/bluetooth/bt_uart_shim.c
Signed-off-by: chao.an <anchao@xiaomi.com>
ld error caused by multiple definition:
ld: arm-none-eabi/lib/thumb/v8-m.main+fp/hard/libsupc++.a(atexit_arm.o): in function `__aeabi_atexit':
atexit_arm.cc:(.text.__aeabi_atexit+0x0): multiple definition of `__aeabi_atexit';
nuttx/staging/libxx.a(libxx_eabi_atexit.o):nuttx/libs/libxx/libxx_eabi_atexit.cxx:75: first defined here
Signed-off-by: chao.an <anchao@xiaomi.com>
