When process a is switched to process b, the address environment is
swapped with a call to group_addrenv(). The stack upon entry will be
a's, and upon exit b's. This will fail, so a neutral stack is required,
either a kernel stack or an IRQ stack.
Infrastructure for an IRQ stack is already in place, so give a hint
that an interrupt stack should be provided if address environments
are enabled.
most licenses have been converted to Apache and the non Apache
licenses have been documented.
We can assume that now it should be the time to remove DISCLAIMER-WIP
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
RISC-V GCC is configured with --enable-initfini-array so it emits an
.init_array section instead of .ctors
Signed-off-by: Gustavo Henrique Nihei <gustavo.nihei@espressif.com>
This is required to avoid the interface header (syscall.h) depending on
the xtensa_swi.h header from the implementation
Signed-off-by: Gustavo Henrique Nihei <gustavo.nihei@espressif.com>
## Summary
`esp32c3_spi2_cmddata()` implements SPI Cmd/Data `SPI_CMDDATA()` for only 3 LCD drivers: ST7735, ST7789 and GC9A01.
This patch removes the check for LCD drivers, so that SPI Cmd/Data will work for all LCD drivers.
More details: https://github.com/apache/incubator-nuttx/pull/5898
## Impact
This change impacts LCD drivers that call `SPI_CMDDATA()`.
Previously `SPI_CMDDATA()` would fail with `ENODEV` for LCD drivers other than ST7735, ST7789 and GC9A01.
After patching, `SPI_CMDDATA()` will work correctly with all LCD drivers.
## Testing
This is a minor patch so no testing is needed.
## Summary
`bl602_spi_cmddata()` implements SPI Cmd/Data `SPI_CMDDATA()` for only 3 LCD drivers: ST7735, ST7789 and GC9A01.
This patch removes the check for LCD drivers, so that SPI Cmd/Data will work for all LCD drivers.
More details: https://github.com/apache/incubator-nuttx/pull/5898
## Impact
This change impacts LCD drivers that call `SPI_CMDDATA()`.
Previously `SPI_CMDDATA()` would fail with `ENODEV` for LCD drivers other than ST7735, ST7789 and GC9A01.
After patching, `SPI_CMDDATA()` will work correctly with all LCD drivers.
## Testing
We tested with LVGL and ST7789 on PineCone BL602:
- [Testing with LVGL](https://github.com/lupyuen/st7789-nuttx#run-lvgl-demo)
As for regular SPI Devices that don't require SPI Cmd/Data, we tested `CONFIG_SPI_CMDDATA=y` with Semtech SX1262 SPI Transceiver on PineCone BL602:
- [Testing Cmd/Data](https://github.com/lupyuen/incubator-nuttx/releases/tag/release-2022-03-30)
The SPSR is used to store the current value of the CPSR when an exception
is taken so that it can be restored after handling the exception.
Each exception handling mode can access its own SPSR.
User mode and System mode do not have an SPSR because they are not
exception handling modes.
Signed-off-by: chao.an <anchao@xiaomi.com>
