Save CONFIG_ARCH_BOARD_CUSTOM when running 'make savedefconfig'
* Save CONFIG_ARCH_BOARD_CUSTOM when running 'make savedefconfig'
* Made grep search expression more specific.
Approved-by: Gregory Nutt <gnutt@nuttx.org>
arm: stm32: codestyle fixes
* arm: stm32f0l0g0: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: stm32f7: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: stm32h7: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: stm32l4: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: stm32: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Approved-by: Gregory Nutt <gnutt@nuttx.org>
Squashed commit of the following:
s32k1xx/s32k146evb/scripts/flash.ld: Update the linker script for the S32K146.
boards/: Hook the S32K146EVB into the configuration and build system.
s32k146_clockconfig.c: Add S32K146 clock configuration.
boards/arm/s32k1xx/s32k146evb/src/s32k146_periphclocks.c: Update peripheral clocking for the S32K146.
arm/s32k1xx/s32k146evb: Initial support fo S32K146EVB. Starting point is just the S32K118EVB with name changes.
boards/arm/s32k1xx/s32k118evb/include/board.h: Add LPUART0 pin disambiguation.
arch/arm/src/s32k1xx/hardware: Add pin mux definitions for S32K116, 118, 142, 144, 146, and 148.
arch/arm/src/s32k1xx/s32k1xx_pin.c and .h: Add support for PIDR register that disables a gneral purpose pin from acting as an input.
arch/arm/src/s32k1xx/s32k1xx_pin.c and .h: The device does not support slew rate controls or open drain (on all the pins). Only pins that are configured for a protocol that requires open-drain (e.g;, LPI2C, LPUART single-wire) will work in open-drain mode.
arch/arm/src/s32k1xx/: Add logic to look up the peripheral clock frequency. Fix baud calcuation logic in s32k1xx_lowputc.c: In no longer tries to enable clocking. That must be done with board logic. Now gets the peripheral functional clock frequency to determine the baud rate.
arch/arm/src/s32k1xx: Add peripheral feature arrays.
Finishes peripheral clock initialization:
arch/arm/src/s32k1xx/s32k11x/s32k11x_clockmapping.c
arch/arm/src/s32k1xx/s32k14x/s32k14x_clockmapping.c
Provide MCU-specific mapping of clock names to PCC control registers.
boards/arm/s32k1xx/s32k118evb/src/s32k118_periphclocks.c
Provides initial clocking for for the S32K118EVB
arch/arm/src/s32k1xx/s32k1xx_periphclocks.c: Add logic to initialize peripheral clocking.
arch/arm/src/s32k1xx/s32k1xx_clockconfig.c: Add SIM clock configuration.
stm32h7 RTC and friends support
* stm32h7:Removed f7 in file path
* stm32f7:Fix overwritten IRQ enabled
System boot order calls clock_initialize then up_initalize.
clock_initialize was setting up the alarm IRQ
up_initalize is initializing the NVIC.
This most likely worked in the past due to a bug in the
NVIC init code that failed to clear the Interrupt enables.
That was fixed in 510b0f7e arch/arm/src: Correct all ARMv7-M
architectures. Interrupts were not be disabled correctly
on power up.
* stm32h7:Ported over F7 RTC
* nucleo-h743zi:Add RTC
Approved-by: Gregory Nutt <gnutt@nuttx.org>
Iobinstrumentation
* mm/iob: Introduces producer/consumer id to every iob call. This is so that the calls can be instrumented to monitor the IOB resources.
* iob instrumentation - Merges producer/consumer enumeration for simpler IOB user.
* fs/procfs: Starts adding support for /proc/iobinfo
* fs/procfs: Finishes first pass of simple IOB user stastics and /proc/iobinfo entry
Approved-by: Gregory Nutt <gnutt@nuttx.org>
arch/arm/src/s32k1xx/s32k1xx_clockconfig.c: Finishes the implementation of the core clock configuration logic.
arch/arm/src/s32k1xx/hardware/s32k1xx_smc.h: Add SMC register definition header file.
arch/arm/src/s32k1xx: Bring in GPIO logic from Kinetis. Looks like the same IP.
This typically happens when there is a lot of data being received over the link. When the XBee stops responding, many times, querying the XBee kicks it out of this state. However, occasionally the XBee is completely locked up and the XBee has to be reset. This change handles these conditions by periodically (if not naturally occuring) querying the XBee. If during any query, the XBee does not respond within a certain number of attempts, the XBee is reset.
arm: sam & tiva: codestyle fixes
* arm: samd2l2: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: samd5e5: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: samv7: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: tiva: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Approved-by: Gregory Nutt <gnutt@nuttx.org>
Mac802154 fixes
* mac802154: Frame Version should have been 1, but was being set to 3 when payload exceeds version 0 capabilities.
* mac802154: Corrects function reference in warning print-out
* mac802154/sixlowpan: Adds warning to build to indicate what is noted in the menu for CONFIG_MAC802154_NTXDESC
Approved-by: Gregory Nutt <gnutt@nuttx.org>
ieee802154/sixlowpan: Removes unnecessary conversions that were happening due to a misunderstanding of byte ordering with EUI-64
# Conflicts:
# drivers/wireless/ieee802154/xbee/xbee_netdev.c
Approved-by: Gregory Nutt <gnutt@nuttx.org>
serial single-wire: add possibility to specify pull-up instead of open drain
Approved-by: David Sidrane <david.sidrane@nscdg.com>
Approved-by: Gregory Nutt <gnutt@nuttx.org>
arm: sam34: codestyle fixes
* arm: sam34: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* arm: sama5: codestyle fixes
After the board restructuration is time for codestyle cleanup
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Approved-by: Gregory Nutt <gnutt@nuttx.org>
