https://github.com/apache/nuttx/pull/11384 has changed the source
address selection of UDP from raddr to laddr, but not all UDP
connections have laddr set, then we need to fallback to get source from
raddr.
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
Weak function sometimes can't have strong implementation linked.
This patch uses NUTTSBI_LATE_INIT config and normal function instead
to avoid those issues.
Signed-off-by: Yanfeng Liu <yfliu2008@qq.com>
The RPTUN_PING option has been replaced by RPMSG_PING but this
use for PERF_EVENTS is left behind, so replace it here as well.
Signed-off-by: Yanfeng Liu <yfliu2008@qq.com>
ctc E246: ["map/mm_map.c" 67/41] left side of '.' or '->' is not struct or union
ctc E260: ["map/mm_map.c" 67/25] not an lvalue
ctc E246: ["map/mm_map.c" 80/3] left side of '.' or '->' is not struct or union
ctc E260: ["map/mm_map.c" 80/3] not an lvalue
Signed-off-by: chao an <anchao@lixiang.com>
It should be possible to use ping without rptun being enabled, so striped rptun_ping out of rptun and rename to rpmsg_ping.
Signed-off-by: wangyongrong <wangyongrong@xiaomi.com>
Previously NuttX runs on little core of K230, this patch allows NuttX to
run on the big core as well.
Within folder `arch/risc-v/src/k230`:
- Changes:
- CMakeLists.txt add k230_hart.c to sources list
- Make.defs add k230_hart.c to sources list
- chip.h add inclusion to k230_hart.h etc
- k230_irq.c move sbi_late_init() to k230_hart.c
- k230_start.c add support to run on big core
- hardware/:
- k230_memorymap.h add T-Head C908 specific CSR
- Additions:
- k230_hart.c sbi_late_init w/ hart initialization
- k230_hart.h header file
Signed-off-by: Yanfeng Liu <yfliu2008@qq.com>
add defintions for vector extension and additional user-mode
extension fields for MSTATUS and SSTATUS registers.
Signed-off-by: Yanfeng Liu <yfliu2008@qq.com>
Adding CMakeLists.txt files to support CMake build system.
Note that only FLAT build works now due to limitations of current
CMake build system.
Signed-off-by: Yanfeng Liu <yfliu2008@qq.com>
SAMA5D2 has UART (TX/RX only) and FLEXCOM USART (with control pins).
UART has only TX/RX, so if I try to use flow control with FLEXCOM USART,
there is no register definition on the UART side and get a compilation error.
Signed-off-by: Takeyoshi Kikuchi <kikuchi@centurysys.co.jp>
Commit 03e5c02 introduced option to have both standard SPI and QSPI
in SPI mode on one system. However this change broke the appearance of
QSPI driver configuration menu entry in menuconfig as it was dependent
on !SAMV7_QSPI_IS_SPI (which is now true for all MCUs having standard
SPI ability in QSPI driver).
This change makes sure the menu is correctly shown when QSPI driver
used.
Signed-off-by: Michal Lenc <michallenc@seznam.cz>
