src/mpfs_emmcsd.c: In function 'mpfs_board_emmcsd_init':
Error: src/mpfs_emmcsd.c:72:40: error: 'SDIO_SLOTNO' undeclared (first use in this function)
finfo("Initializing SDIO slot %d\n", SDIO_SLOTNO);
^~~~~~~~~~~
src/mpfs_emmcsd.c:72:40: note: each undeclared identifier is reported only once for each function it appears in
Error: src/mpfs_emmcsd.c:83:55: error: 'SDIO_MINOR' undeclared (first use in this function); did you mean 'SHRT_MIN'?
finfo("Bind SDIO to the MMC/SD driver, minor=%d\n", SDIO_MINOR);
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
- Add defconfig and board specific files
- Create mpfs/common for code which is shared between MPFS boards.
- Add support for GPIO driven EMMCSD mux.
- Move DDR Libero definitions from arch to boards.
Signed-off-by: Jani Paalijarvi <jani.paalijarvi@unikie.com>
E51 may configure the L1 and L2 caches. Once configured,
no reconfiguration is possible after hardware reset is
issued.
L2 is 16-way set associative with write-back policy. The
size 2 MB, from which 1 MB is utilized with the values
provided here. That's a total of 8 ways. The rest of the
L2 is left out for the bootloader usage.
mpfs_enable_cache() first checks the bootloader usage
doesn't overlap with the cache itself, thus providing a
set of functional values.
Signed-off-by: Eero Nurkkala <eero.nurkkala@offcode.fi>
This adds DDR training. The training has a small chance of failing,
and then the training is restarted.
DDR training cannot be done meaningfully while the software is
in DDR. If the system is intended to run from eNVM, like a
bootloader, the linker script should be tuned to utilize the envm
region as follows:
envm (rx) : ORIGIN = 0x20220100, LENGTH = 128K - 256
l2lim (rwx) : ORIGIN = 0x08000000, LENGTH = 1024k
256 bytes are reserved for the system; The fixed block may be
installed from the 'hart-software-services' -repository:
https://github.com/polarfire-soc/hart-software-services.git
For example, the 256-byte image: hss-envm-wrapper-bm1-dummySbic.bin
may be prepended on the nuttx bootloader image in the following
manner:
cat hss-envm-wrapper-bm1-dummySbic.bin > nuttx_bootloader.bin
cat nuttx.bin >> nuttx_bootloader.bin
riscv64-unknown-elf-objcopy -I binary -O ihex --change-section-lma
*+0x20220000 nuttx_bootloader.bin flashable_image.hex
This provides an image 'flashable_image.hex' that may be flashed on
the eNVM region via Microsemi Libero tool.
Signed-off-by: Eero Nurkkala <eero.nurkkala@offcode.fi>
Add a driver for CorePWM block, which can be instantiated on PolarFire SOC FPGA
This supports 2 CorePWM blocks on the FPGA. One CorePWM block provides 8 PWM output signals
