Summary:
- This commit adds 'select ARM_HAVE_WFE_SEV' to ARCH_CHIP_RP2040
- Now NuttX spinlock uses WFE/SEV to reduce power consumption
- Also, modify a comment on rp2040
Impact:
- rp2040 only
Testing:
- Tested with raspberrypi-pico:smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
You can find them used in the ROM version of memcpy.
While it might be controversial if it's a good idea to use the ROM version
of these functions, it's nicer to support more instructions here anyway.
As ESP32 has 2 I2C interfaces and BMP180 is a I2C sensor, the criterias to use BMP180 in I2C0 or I2C1 are:
1- First, bring-up routines search for BMP180 in I2C0.
If BMP180 is found in I2C0, then /dev/press0 is created.
2- If BMP180 cannot be registered in I2C0, bring-up routines search for it in I2C1.
If BMP180 is found in I2C1, then /dev/press0 is created.
It means only one BMP180 could be suported in Nuttx. In my tests I've observed
that BMP180 example application doesn't seem to work with /dev/press1 BMP180 device,
therefore even BMP180 is found in I2C1, it'll be registered as /dev/press0 device.
Summary:
- In the previous implementation, the build system stops if
PICO_SDK_PATH is not set.
- However, this behavior is not good for CI. Because the path
is only used to generate a flash image.
- This commit fixes this issue
Impact:
- rp2040 only
Testing:
- Tested with and without PICO_SDK_PATH
It was missing and it wasn't possible to enable I2C (0 and/or 1)
before this fix.
To sum up, this fix implements a I2C register function in ESP32
bring-up routines (esp32_bringup.c) and call if for I2C0 and/or
I2C1 during ESP32 bringup (these function callings are conditioned
by CONFIG_ESP32_I2C (to check if I2C support has been configured),
CONFIG_ESP32_I2C0 (to check if I2C0 support has been configured)
and CONFIG_ESP32_I2C1 (to check if I2C1 support has been configured).
Once this fix is implemented, /dev/i2c0 and/or /dev/i2c1 interfaces
become available and work fine.
Use the usual while loop idiom when parsing arguments.
Add more options to the script to be able to specify the name of the
NuttX binary and final image.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
The GPIO example was also extended to include testing an interrupt pin.
Co-authored-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Co-authored-by: Alan Carvalho <alan.carvalho@espressif.com>
This commits adds support for the ESP32-C3 IO Mux and GPIO Matrix. It
also includes necessary board logic to run the GPIO example with 2
outputs.
Co-authored-by: Alan Carvalho <alan.carvalho@espressif.com>
Co-authored-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
