This commit adds support for dead time delay to SAMv7 PWM driver. The
dead time can be used to delay an active PWM output at the begining
of the period. This can be used for H bridge control for example.
The values are to be set from the application level. It is required
to allow config option PWM_DEADTIME in order to support dead time delay.
Signed-off-by: Michal Lenc <michallenc@seznam.cz>
PWM drivers usually supports dead time generators that automatically
insert output activation delay for complementary PWM outputs. This
is usefull for some control purposes as control of H bridge for example.
This commit adds an application to driver interface that can be used
to set up those delays (if supported by the selected architecture)
directly from the application. The set up remains the same as for duty
cycle value.
The whole addition is by default disabled. It can be enabled by config
option PWM_DEADTIME.
Signed-off-by: Michal Lenc <michallenc@seznam.cz>
Initial documentation page for SAMv7 MCU is added. There are still
board pages to be added in the future.
Signed-off-by: Michal Lenc <michallenc@seznam.cz>
Summary:
- I noticed that recent mm_heap changes causes a crash with
stm32f4discovery:kostest
- This is a tentative solution to avoid the crash
Impact:
- None
Testing:
- Tested with stm32f4discovery board
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
add arm64_serialinit/arm64_earlyserialinit function prototype
to arm64_internal.h as common function for arm64 based chip.
Testing with ostest in SP and SMP
Signed-off-by: qinwei1 <qinwei1@xiaomi.com>
Echoing console's input is now performed by the serial driver
(https://github.com/apache/nuttx/pull/8691). In order to keep old
behavior of CR being echoed by the device, it's needed to detected
whenever NL is being echoed and send CR before sending it.
Hardware flow control for serial requires the usage of DMAC channels
which is not yet supported for SAMv7 MCU. However the same config option
CONFIG_SERIAL_IFLOWCONTROL is also used for USB CDC/ACM flow control which
works well. Therefore the warning message should be raised only if
flow control is configured for USART driver and not for USB CDC/ACM.
Signed-off-by: Michal Lenc <michallenc@seznam.cz>
Return the error code when all gets occur when an error is wrong
and return immediately when obtaining any valid data
Signed-off-by: yinshengkai <yinshengkai@xiaomi.com>
