Summary:
- This commit fixes a compile warning if CONFIG_ARCH_INTERRUPTSTACK is set
Impact:
- None
Testing:
- Built with esp32-devkitc:smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- Recently I noticed that ESP32-DevKitC-32D suddenly stops
during receiving ping packets from PC after 10-20mins
- Actually, sometimes memory leak happened when some device
sent a big broadcast packet periodically on the network
- This commit fixes this issue by calling esp_wifi_free_eb()
in the case that the packet exceeds WLAN_BUF_SIZE.
- Also, this commit applies the same logic in the case that
the Wi-Fi interface is down
Impact:
- None
Testing:
- Tested with esp32-devkitc:wapi
Suggested-by: YAMAMOTO Takashi <yamamoto@midokura.com>
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- This commit introduces a driver-specific spinlock to cxd56.c
to improve performance in SMP mode.
Impact:
- cxd56.c in SMP mode only
Testing:
- Tested with nxplayer and nxrecorder with the following configs
- spresense:wifi, spresense:wifi_smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Otherwise, long-sleeping system calls using nxsig_timedwait
are not actually interrupted.
Tested with "ntpcstop" using lm3s6965-ek:qemu-protected config.
Summary:
- Recently I noticed that the nxhello caused hard fault
- Finally, I found that mq_open() had been changed to nxmq_open()
but the calling convention was not correct.
- This commit fixes this issue.
Impact:
- nxmu_server.c only
Testing:
- Tested with nxhello, nxlines & nxdemo with the following configs
- spresense:wifi, spresense:wifi_smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
I2C3 not worked due to it's GPIO pin definition has been missing on board.h.
Fix it through include two pin macros on stm32l4x3xx_pinmap.h to board.h.
GPIO_I2C3_SCL and GPIO_I2C3_SDA is pointing A7 and B4 respectively.
1. Don't use the bootloader and partition-table
binaries from a hello-world example. Rather the ESPTOOL_BINDIR variable
can be used to give a user-defined location.
2. The ESPTOOL_BINDIR variable has to be as generic as possible. Don't
assume any board configuration.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
Summary:
- This commit introduces driver-specific spinlock in cxd56_serial.c
to improve performance
Impact:
- SMP only
Testing:
- Tested with spresense:wifi and spresense:wifi_smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- This commit introduces spinlock_t for #ifndef CONFIG_SPINLOCK
which is useful for the non-SMP case because it does not consume
memory
Impact:
- None:
Testing:
- N/A
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
