If we only enable one of `CONFIG_NET_ARP_SEND` and
`CONFIG_NET_ICMPv6_NEIGHBOR`, both IPv4 and IPv6 traffic will send
ARP or NDP, which causes problem.
Example:
`CONFIG_NET_ARP_SEND=n`
`CONFIG_NET_ICMPv6_NEIGHBOR=y`
Wrong:
IPv4 traffic (`PF_INET`) goes into `icmpv6_neighbor`, which
definitely causes problem.
Correct:
IPv4 traffic doesn't call anything, IPv6 traffic calls `icmpv6_neighbor`
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
- Fix `ip6_map_ipv4addr` and `ip6_get_ipv4addr` macro to work under
different endianness.
- Use `iob_reserve` instead of `iob_trimhead` in `udp_datahandler`.
- Because we may set `sockaddr_in6` into IPv4 header, which causes
`offset` become negative. `iob_reserve` can hold this case while
`iob_trimhead` cannot.
- Select IPv4 domain in send case.
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
The netdev of link-local address cannot be auto decided, and the link-local address should always be reguarded as address on local network.
The problem we met:
When using `icmpv6_autoconfig` with multiple netdev, the `icmpv6_neighbor` may take out wrong netdev with ip address already set, then it may send solicitation with wrong address (`dev->d_ipv6draddr`) on wrong device, and regard the link-local address as conflict (because `dev->d_ipv6draddr` exists on this network).
Signed-off-by: Zhe Weng <wengzhe@xiaomi.com>
When a task needs to send data, a callback is allocated and the
transmission is happening in a worker task through devif_send.
Synchronization between the two tasks (sender & worker) is
achieved by a semaphore.
If devif_send fails, this semaphore was never posted, leaving
the sending task blocked indefinitely. This commit fixes this
by checking the return code of netif_send, and posting this
semaphore in case of failure.
Polling then stops, and execution is resumed on the sending
task.
Allocate the device buffer only if the protocol really need to send data.
not all protocols require the driver to prepare additional iob before
sending, especially UDP, each iob reserves l2/l3 header in advance
after prepare write buffer, net device could reuse this entry to send directly
Signed-off-by: chao an <anchao@xiaomi.com>
fix build break if enable CONFIG_NET_IPv6 only
In file included from tcp/tcp_sendfile.c:38:
tcp/tcp_sendfile.c: In function ‘sendfile_eventhandler’:
tcp/tcp_sendfile.c:173:27: error: ‘struct tcp_conn_s’ has no member named ‘domain’
173 | DEBUGASSERT(conn->domain == PF_INET6);
| ^~
Signed-off-by: chao an <anchao@xiaomi.com>
If the udp socket not connected, it is possible to have
multi-different destination address in each iob entry,
update the remote address every time to avoid sent to the
incorrect destination.
Signed-off-by: chao.an <anchao@xiaomi.com>
