This provides an alternate tickless scheduling method, which uses the riscv
mtimer as a timebase, allowing the time and timeh registers to used
throughout an application.
The exiting tickless method, using Litex's timer0 has been left in place, as
it is a more performant option, but currently has the potential issue
identified in #11189.
This temporary fix is just to unblock CI errors:
```
Configuration/Tool: imx93-evk/bootloader
...
aarch64-none-elf-ld: region `ocram' overflowed by 88 bytes
```
Signed-off-by: Yanfeng Liu <yfliu2008@qq.com>
Search and replace ARCH_BOOT_EL3 with more generic
ARCH_ARM64_EXCEPTION_LEVEL that holds the EL level
in an integer variable.
Signed-off-by: Eero Nurkkala <eero.nurkkala@offcode.fi>
This provides a capable bootloader that may be run from OCRAM.
The OCRAM contains regions that are always zero, so the linker
file avoids those with best effort.
iMX9 infrastructure expects:
- 0x20480000 (Start of OCRAM, AHAB)
- 0x2049a000 (NuttX or SPL)
- 0x204e0000 (ARM Trustzone, not used)
When started from SD-card, the offsets are:
- 0x1f000 with AHAB
- 0xa000 without AHAB
Signed-off-by: Eero Nurkkala <eero.nurkkala@offcode.fi>
rv-virt support different size of ksram and pgmem region, but the
fixed value in the link script limits this function. As nuttx supports
preprocessing the link script. It is better to use the config value
to compute the memory layout. This also make all kernel build use the
same script.
Signed-off-by: Inochi Amaoto <inochiama@outlook.com>
Add partition parsing logic to emmcsd and support for configuring either CDCACM alone or
both CDCACM and USBMCS for composite mode.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
The original names are confusing; the symbols' addresses point to the start and end of the
sbi executable ram area. This may also reside in l2lim and not in ddr, depending on the
configuration, and this is defined in the linker script.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
Whenever a MTD partition is set, this change limits its size
according to the flash size, avoiding the MTD partition to be
greater than the actual flash size.
ESP32 SoC use a static allocated array as idle stack. To fit
the existed idle stack allocation, make idle stack allocated
from ebss for the whole esp32 series.
Signed-off-by: Inochi Amaoto <inochiama@outlook.com>
1. Adjust code to avoid PM wakelock->count less than or equal to 0.
2. Fix some document format issues.
Signed-off-by: chenwen@espressif.com <chenwen@espressif.com>
Although almost all board support allocating idle stack after ebss,
bl602 have a different memory layout for idle stack. To unify them,
make idle stack allocated from ebss for bl602.
Signed-off-by: Inochi Amaoto <inochiama@outlook.com>
