Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
The vaddr field in TLBI means: Bits[55:12] of the virtual address to match.
This basically means the page offset of the virtual address, so the input
vaddr must be shifted to the page offset.
Reference TLBI VALE1IS register description from ARMv8-A reference manual.
The 12:0 bits in table descriptors are RES0 and AF is the 10th bit, so
it is not valid to set it in this case.
Fix this by moving AF to the common MMU_MT_NORMAL_FLAGS field
Make sure the user L1 page is updated to system memory when the kernel
mappings are copied.
Also, flush the I-cache when switching address environments.
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
According to rfc1112, section 7.2:
"An ICMP error message (Destination Unreachable, Time Exceeded, Parameter Problem, Source Quench, or Redirect) is
never generated in response to a datagram destined to an IP host group."
Signed-off-by: zhangshuai39 <zhangshuai39@xiaomi.com>
The libmad and libmp3lame libraries have been ported to
apps/audioutils and will be compiled with NuttX.
Signed-off-by: shizhenghui <shizhenghui@xiaomi.com>
This enables CMake based build for sim:ostest. Flags which
are set by set_source_files_properties are not reflected in
final build. Changing these to target_compile_options makes
CMake build runnable.
Signed-off-by: Daniel Jasinski <jasinskidaniel95szcz@gmail.com>
Add new driver frameworks: force feedback for vibrator, like linux,
unify vendor vibrator driver using.
Incorporating a force feedback-based driving framework to replace the
conventional driver/motor setup for controlling vibrators not only
enhances the precision and responsiveness of the haptic feedback but
also aligns better with the advancements in Linux-based driver systems.
refs docs link: https://www.kernel.org/doc/html/v4.19/input/ff.html
Signed-off-by: dongjiuzhu1 <dongjiuzhu1@xiaomi.com>
1. Should check the vmid in ivshmem_remove() when release irq instead
check the ivdev->reg;
2. Add vmid check in ivshmem_probe() because ivshmem driver only support
vmid == 0 or 1 for now in NuttX;
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
Add common ivshmem driver, provide the ivshmem bus mechisam, so
many ivshmem based driver can change to pci_ivshmem based
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
Rptun is a rptun fremework driver base on the Inter-Virtual Machine
Share Memory Device.
With this driver, two NuttX runs in different QEMU can communicate
with each other by the rpmsg api.
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
We can see them in ifconfig:
ap> ifconfig
wlan0 Link encap:Ethernet HWaddr 42:64:7f:b3:12:03 at UP mtu 1500
inet addr:10.0.1.2 DRaddr:10.0.1.1 Mask:255.255.255.0
inet6 DRaddr: ::
RX: Received Fragment Errors Bytes
00000b9b 00000000 00000000 21daf5
IPv4 IPv6 ARP Dropped
00000a33 00000137 00000031 00000000
TX: Queued Sent Errors Timeouts Bytes
00000ac4 00000ac4 00000000 00000000 1a2103
Total Errors: 00000000
Signed-off-by: meijian <meijian@xiaomi.com>
Coredump need call the block read/write ops in interrupt
Not consider the ops called in thread and intterupt simultaneously.
Only used for coredump now.
Signed-off-by: Bowen Wang <wangbowen6@xiaomi.com>
SO_SNDBUF takes effect only after the connection in STREAM mode
is successful
support full life cycle modification of SO_RCVBUF
Signed-off-by: zhanghongyu <zhanghongyu@xiaomi.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
