Summary:
- This commit adds stack coloration for the idle task
Impact:
- rp2040 with CONFIG_STACK_COLORATION=y
Testing:
- Tested with nsh, nshsram and smp configurations
- NOTE: CONFIG_STACK_COLORATION=y needs to be added
Summary:
- The NuttX for raspberrypi-pico boots via the boot_stage2 provided
by the pico-sdk which sets the MSP at the end of the SRAM.
- However, the NuttX expects the MSP is set to the top of the idle stack.
- This commit fixes this issue.
Impact:
- None
Testing:
- Tested with nsh, nshsram and smp configrations
Summary:
- SP_SECTION was introduced to allocate spinlock in non-cachable
region mainly for Cortex-A to stabilize the NuttX SMP kernel
- However, all spinlocks are now allocated in cachable area and
works without any problems
- So SP_SECTION should be removed to simplify the kernel code
Impact:
- None
Testing:
- Build test only
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- The CONFIG_SMP_IDLETHREAD_STACKSIZE was introduced to optimize
the idle stack size for other than CPU0
- However, there are no big differences between the idle stacks.
- This commit removes the config to simplify the kernel code
Impact:
- All SMP configurations
Testing:
- Tested with ostest with the following configs
- spresense:smp, spresense:rndis_smp
- esp32-devkitc:smp (QEMU), maix-bit:smp (QEMU)
- sabre-6quad:smp (QEMU), sabre-6quad:netnsh_smp (QEMU)
- raspberrypi-pico:smp, sim:smp (x86_64)
Signed-off-by: Masayuki Ishikawa <asayuki.Ishikawa@jp.sony.com>
stm32h7:Serial Use Idel to poll RX DMA
stm32h7:Serial Do not loop in an ISR!
stm32h7:Serial signal txdma completion with semaphore
stm32h7:Serial Apply formatting suggestions from code review
Co-authored-by: Mateusz Szafoni <raiden00pl@gmail.com>
stm32h7: Serail Add Power Managment (Untested)
arch: Allocate the space from the beginning in up_stack_frame
and modify the affected portion:
1.Correct the stack dump and check
2.Allocate tls_info_s by up_stack_frame too
3.Move the stack fork allocation from arch to sched
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
For unknown reasons this message may interferre with the calibration
procedure and result in invalid calibariton data.
We leave only a message informing about the end of the the calibration.
The problem was observed for STM32G4 + IHM16M1.
Change the logic for allocating user heap for PROTECTED_BUILD:
- Don't rely on SRAM1_END alignment
- Make better use of MPU subregions when allocating the heap
- Don't duplicate the calculation of user heap start in kernel heap
allocation; use the previous calculation directly
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
