boards/z80/ez80/z20x/configs/w25boot/defconfig: Increase size of serial Tx buffer.
boards/z80/ez80/z20x/src/w25_main.c: Add some fflush() in necessary places. Greatly improves the usability of the UI.
boards/z80/ez80/z20x/README.txt: Trival update to README
drivers/serial/serial.c and tcdrain.c: Correct some typos.
- boards/z80/ez80/z20x/scripts/z20x_*.linkcmd: Reduce from 4 to 1 wait state. That i sufficient because of the slow clocking of the eZ80F92
- boards/z80/ez80/z20x/src/w25_main.c: Replace CRC algorithm with simple, less time consuming check sum.
- boards/z80/ez80/z20x/configs/nsh: Rename the nsh_ram configuration to just nsh
- boards/z80/ez80/z80x/configs/hello: Add simpler program to make debugging the loader easier.
arch/z80/src/ez80/ez80_timerisr.c: Correct a mismatch between the programmed reload value and the timer input clock frequency.
arch/z80/src/ez80/ez80f92.h: Correct error in timer input clock divider: Bits 2-3, not bits 3-4.
boards/z80/ez80/z20x/src/w25_main.c: Correct an uninitialized return value; private function was not declard static.
boards/z80/ez80/z20x: Increase RX buffer size to 4Kb, reduce BAUD to 2400 in w25boot configuration
arch/z80/src/ez80/ez80_serial.c: Reduce Rx FIFO trigger level for eZ80F92 to 1 so that will respond more quickly to incoming data.
board/z80/ez80/*/scripts/Make.defs: Fix optimization definition use in assembly flags. It was using the compiler optimization settings instead of the assembler optimization settings. Hence, enabling optimization would could cause assembler command line errors.
arch/z80/src/ez80/Toolchain.defs: Back out some work arounds. Now compiler optimization flags can again set set without assembler command line errors.
boards/z80/ez80/z20x/README.txt: Trivial update to size/optimization discussion.
The eZ80F92 interrupt controller is very different from the eZ80F91. The eZ80F91 has:
1. Four byte interrupt vectors
2. The vector base address register is 16-bit so the vector table can lie in RAM
Whereas the eZ80F92 has:
1. Two byte interrupt vectors
2. An 8-bit vector base address
This means that the vectors must lie in the first 16-bits of FLASH and there must be a "trampoline" to get to interrupt handlers outside of the first 64-Kb of FLASH.
arch/z80/src/ez80/Toolchain.defs: Correct some CFLAGS when optimization suppressed.
arch/z80/src/ez80/Kconfig arch/z80/src/ez80/ez80_emac.c: Remove configuration option for selecting EMAC RAM address. This is duplicated and possibly conflicting. The correct address for the RAM is provided in the linker command file. The RAM should be configured once and using this single definitions.
arch/z80/src/ez80/ez80_startup.asm and arch/z80/src/ez80/ez80f9*_init.asm. Move RAM and FLAH intialization out of MCU-specific logic to common start-up logic. We cannot call any functions until SRAM is initialized and the stack is properly initialized because the return address is stored on the stack. Use internal SRAM for the IDLE stack to avoid the chicken'n'egg problem.
boards/z80/ez80/z20x/configs/sdboot/sdboot.zdsproj: Discuss build environments.
