/****************************************************************************
 * boards/arm/stm32l4/b-l475e-iot01a/src/stm32_autoleds.c
 *
 * Licensed to the Apache Software Foundation (ASF) under one or more
 * contributor license agreements.  See the NOTICE file distributed with
 * this work for additional information regarding copyright ownership.  The
 * ASF licenses this file to you under the Apache License, Version 2.0 (the
 * "License"); you may not use this file except in compliance with the
 * License.  You may obtain a copy of the License at
 *
 *   http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
 * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.  See the
 * License for the specific language governing permissions and limitations
 * under the License.
 *
 ****************************************************************************/

/* LEDs
 *
 * A single LED is available driven by PA13.
 *
 * These LEDs are not used by the board port unless CONFIG_ARCH_LEDS is
 * defined.  In that case, the usage by the board port is defined in
 * include/board.h and src/sam_autoleds.c. The LEDs are used to encode
 * OS-related events as follows:
 *
 *   ------------------- ----------------------- ------
 *   SYMBOL              Meaning                 LED
 *   ------------------- ----------------------- ------
 *   LED_STARTED         NuttX has been started  OFF
 *   LED_HEAPALLOCATE    Heap has been allocated OFF
 *   LED_IRQSENABLED     Interrupts enabled      OFF
 *   LED_STACKCREATED    Idle stack created      ON
 *   LED_INIRQ           In an interrupt         N/C
 *   LED_SIGNAL          In a signal handler     N/C
 *   LED_ASSERTION       An assertion failed     N/C
 *   LED_PANIC           The system has crashed  FLASH
 *
 * Thus is LED is statically on, NuttX has successfully  booted and is,
 * apparently, running normally.  If LED is flashing at approximately
 * 2Hz, then a fatal error has been detected and the system has halted.
 */

/****************************************************************************
 * Included Files
 ****************************************************************************/

#include <nuttx/config.h>
#include <debug.h>

#include <nuttx/board.h>
#include <arch/board/board.h>

#include "stm32l4_gpio.h"
#include "b-l475e-iot01a.h"

#ifdef CONFIG_ARCH_LEDS

/****************************************************************************
 * Public Functions
 ****************************************************************************/

/****************************************************************************
 * Name: board_autoled_initialize
 ****************************************************************************/

void board_autoled_initialize(void)
{
  /* Configure LED gpio as output */

  stm32l4_configgpio(GPIO_LED2);
}

/****************************************************************************
 * Name: board_autoled_on
 ****************************************************************************/

void board_autoled_on(int led)
{
  if (led == 1 || led == 3)
    {
      stm32l4_gpiowrite(GPIO_LED2, true);
    }
}

/****************************************************************************
 * Name: board_autoled_off
 ****************************************************************************/

void board_autoled_off(int led)
{
  if (led == 3)
    {
      stm32l4_gpiowrite(GPIO_LED2, false);
    }
}

#endif /* CONFIG_ARCH_LEDS */