README.txt ========== STM32F429I-DISCO LTDC Framebuffer demo example Configure and build ------------------- cd tools ./configure -a stm32f429i-disco/fb cd .. make Note! In the current implementation the DMA2D driver only supports clut pixel format if the LTDC driver it does. Otherwise it will not be compatible with the NX framework. If CONFIG_FB_CMAP is configured, NX expects that any pixel format supports color lookup tables. This is also the case for non CLUT formats e.g. FB_FMT_RGB16_565. This may result in wrong color representation by NX if the pixel format is unequal to FB_FMT_RGB8. On the other hand layers with CLUT pixel format are not supported by the DMA2D controller, in the case they will be used as destination layer for the following operations: - blit - blend - fillarea To enable clut support in both LTDC and DMA2D driver the following configurations are valid: 1. - Enable LTDC_INTERFACE and LAYER1/LAYER2 - Layer1 FB_FMT_RGB8 - Layer2 any non clut format But Layer2 can only be used as destination layer for dma2d operations above. This configuration is not compatibly to NX because LAYER2 will be referenced by up_fbgetvplane and is an invalid CLUT pixel format. 2. - Enable LTDC_INTERFACE and LAYER1/LAYER2 - Layer2 FB_FMT_RGB8 - Layer1 any non clut format But Layer1 can only be used as destination layer for dma2d operations above. This configuration should be compatibly to NX because LAYER2 will be referenced by up_fbgetvplane and is an valid CLUT pixel format. All other non clut configuration work fine. If using the DMA2D controller without the LTDC controller e.g. camera interface than enable CONFIG_FB_CMAP and optional CONFIG_FB_TRANSPARENCY in your board specific configuration. Loading ------- st-flash write nuttx.bin 0x8000000 Executing --------- The ltdc is initialized during boot up. Interaction with NSH is via the serial console at 115200 8N1 baud. From the nsh comandline execute the fb example: nsh> fb The test will put a pattern of concentric squares in the framebuffer and terminate.