# # For a description of the syntax of this configuration file, # see the file kconfig-language.txt in the NuttX tools repository. # if ARCH_BOARD_SPRESENSE config CXD56_SPIFLASHSIZE hex default 0x400000 depends on CXD56_SFC ---help--- Specify the SPI flash total available size for the application. This value is generally set half of SPI flash device capacity. config SPRESENSE_EXTENSION bool "Extension board" default n select CXD56_CUSTOM_PINCONFIG ---help--- Indicates to the configuration that an SPresense extension board is present. If there is no extension board attached, the SPresense may run in a low-power mode by default (as determined by the CONFIG_CXD56_CUSTOM_PINCONFIG option). If an extension board is present, then the SPresense will need to run at a higher power mode, selected by this option. config SDCARD_TXS02612 bool "SD Card TXS02612 port expander with voltage level translation" default y ---help--- Enable TXS02612 Dual Voltage Level Translator for SD-Card interface. This device is used in SPD-003C board. if SDCARD_TXS02612 choice prompt "TXS02612 port" default SDCARD_TXS02612_PORT0 config SDCARD_TXS02612_PORT0 bool "Port 0" config SDCARD_TXS02612_PORT1 bool "Port 1" endchoice # "TXS02612 port" endif # SDCARD_TXS02612 if LCD choice prompt "LCD SPI connection" default LCD_ON_EXTENSION_BOARD config LCD_ON_EXTENSION_BOARD bool "Extension board: SPI4" select CXD56_SPI4 ---help--- Display connected to extension board. config LCD_ON_MAIN_BOARD bool "Main board: SPI5" select CXD56_SPI5 ---help--- Display connected to main board. endchoice endif endif