# # For a description of the syntax of this configuration file, # see the file kconfig-language.txt in the NuttX tools repository. # if ARCH_BOARD_RASPBERRYPI_PICO_W config RP2040_FLASH_BOOT bool "flash boot" default y ---help--- If y, the built binary can be used for flash boot. If not, the binary is for SRAM boot. config RP2040_FLASH_CHIP string "Second stage boot loader" default "w25q080" ---help--- This is the name of the Pico-SDK second stage boot loader to use for this board. This board using a Q16 flash chip which is compatible with the w25q080 boot loader. Basically this option should not be changed. config RP2040_UF2_BINARY bool "uf2 binary format" default y ---help--- Create nuttx.uf2 binary format used on RP2040 based arch. config RP2040_LCD_SPI_CH int "RP2040 LCD SPI channel number" default 0 range 0 1 depends on LCD ---help--- Select SPI channel number to use LCD display. config RP2040_ENC28J60_SPI_CH int "ENC28J60 SPI channel number" default 1 range 0 1 depends on ENC28J60 ---help--- Select SPI channel number to use ENC28J60 ethernet. config RP2040_ENC28J60_INTR_GPIO int "ENC28J60 interrupt GPIO pin assign" default -1 range -1 29 depends on ENC28J60 config RP2040_ENC28J60_RESET_GPIO int "ENC28J60 reset GPIO pin assign (optional)" default -1 range -1 29 depends on ENC28J60 menuconfig RP2040_INFINEON_CYW43439 bool "Has Infineon cyw43439 WiFi chip" depends on IEEE80211_INFINEON_CYW43439 default y endif if RP2040_INFINEON_CYW43439 config CYW43439_FIRMWARE_BIN_PATH string "Path to Infineon 43439 firmware file" default "${PICO_SDK_PATH}/lib/cyw43-driver/firmware/43439A0-7.95.49.00.combined" ---help--- This should be a path to a file containing both the cyw43439 firmware and the CLB blob. The firmware should be padded to a 256 byte boundary and then the CLM blob should be appended. If this file is updated, check the CYW43439_FIRMWARE_LEN below to make sure it reflects the un-padded length of the firmware part. config CYW43439_FIRMWARE_LEN int "Infineon 43439 firmware length (bytes)" default 224190 ---help--- This is the length of just the base firmware in the firmware file specified by the "Path to Infineon 43439 firmware file" configuration option. This length does not include the length of any padding nor the length of the appended clm_blob. If a clm_blob is present in the firmware file, this length will be less than the length of the whole file. endif