9a654b658e
This implements the changes required to genreate the pdf version of the documentation. The pdf will be generated as a build artifact attached to the build. This is the first patch to enable this a follow on patch to the website repo will publish the pdf to the NuttX website.
62 lines
1.5 KiB
ReStructuredText
62 lines
1.5 KiB
ReStructuredText
=======================
|
|
MakerDiary nRF52832-MDK
|
|
=======================
|
|
|
|
The `nRF52832-MDK <https://wiki.makerdiary.co/nrf52832-mdk>`_ is a development board for
|
|
the nRF52832 SoC from Nordic. It features 24 I/Os an on-board RGB led and a chip antenna.
|
|
It also includes an embedded DAPlink debugger which allows to flash/debug and monitor UART
|
|
from the USB port.
|
|
|
|
.. figure:: pinout.png
|
|
:align: center
|
|
|
|
Pinout diagram
|
|
|
|
Features
|
|
========
|
|
|
|
- nRF52832 MCU, 512K FLASH, 64K SRAM
|
|
- 32768 Hz crystal
|
|
- Embedded DAPlink debugger (debug/flash and monitor serial)
|
|
- Reset button
|
|
- Programming mode RGB LED indicator (CDC, MSD or DAP)
|
|
- Power indicator LED
|
|
- User RGB LED
|
|
- Inductor + capacitor for DC/DC mode
|
|
|
|
Pin Mapping
|
|
===========
|
|
|
|
===== ========== ==========
|
|
Pin Signal Notes
|
|
===== ========== ==========
|
|
P0.24 Blue LED Active LOW
|
|
P0.23 Red LED Active LOW
|
|
P0.22 Green LED Active LOW
|
|
P0.20 UART TX
|
|
P0.19 UART RX
|
|
===== ========== ==========
|
|
|
|
Configurations
|
|
==============
|
|
|
|
nsh
|
|
---
|
|
|
|
Basic NuttShell configuration (console enabled in UART0, exposed via USB connection, at 115200 bps).
|
|
|
|
sdc
|
|
---
|
|
|
|
Enables Nordic's SoftDevice controller and uses nimBLE for the host-layer.
|
|
The ``nimble`` test application can be used to enable a simple GATT server.
|
|
|
|
Flash & Debug
|
|
=============
|
|
|
|
Both flashing and debugging are done using the embedded DAPlink debugger. OpenOCD can be invoked
|
|
in the following way to flash::
|
|
|
|
openocd -f interface/cmsis-dap.cfg -f target/nrf52.cfg -c "program nuttx/nuttx.bin 0x0000000 verify reset; shutdown"
|
|
|