53 lines
1.2 KiB
ReStructuredText
53 lines
1.2 KiB
ReStructuredText
==========================
|
|
Sparkfun nRF52832 Breakout
|
|
==========================
|
|
|
|
The `Sparkfun nRF52832 Breakout <https://wiki.makerdiary.co/nrf52832-mdk>`_ is basic board providing
|
|
access to all I/O pins, a 32kHz crystal and LED.
|
|
|
|
.. figure:: board.jpg
|
|
:align: center
|
|
:width: 50%
|
|
|
|
Sparkfun nRF52832 Breakout
|
|
|
|
Features
|
|
========
|
|
|
|
- nRF52832 MCU (QFAAB0), 512K FLASH and 64 SRAM
|
|
- Reset and user button
|
|
- Power LED (blue) and user LED (red)
|
|
- 32768 Hz crystal
|
|
- NFC antenna connection pads
|
|
- Cortex Debug connector
|
|
- UART + SWD header
|
|
|
|
Pin Mapping
|
|
===========
|
|
|
|
===== =========== ==========
|
|
Pin Signal Notes
|
|
===== =========== ==========
|
|
P0.06 User Button Active LOW
|
|
P0.07 User LED Active LOW
|
|
P0.26 UART TXO
|
|
P0.27 UART RXI
|
|
===== =========== ==========
|
|
|
|
Configurations
|
|
==============
|
|
|
|
nsh
|
|
---
|
|
|
|
Basic NuttShell configuration (console enabled in UART0, at 115200 bps).
|
|
|
|
Flash & Debug
|
|
=============
|
|
|
|
An external debugger is required, so the procedure to flash/debug depends on the chosen interface. Using an ST-Link V2
|
|
you can flash using OpenOCD with::
|
|
|
|
openocd -f interface/stlink-v2.cfg -f target/nrf52.cfg -c "program nuttx/nuttx.bin 0x0000000 verify reset; shutdown"
|
|
|