14fb37c995
ieee802154: Simplifies notify() and rxframe() calls to a single notify() call. dataind's and all other "notifs" are now "primitives" which aligns with standard terminology * mac802154: Adds missing breaks from case statement * sixlowpan: Fixes bad logic where ACK is not requested if address is not a broadcast * ieee802154: Simplification of "notifs" and "datainds" to generic primitives passed via a single notify call to the layer above the MAC * Directories.mk should reference CONFIG_WIRELESS instead of CONFIG_DRIVERS_WIRELESS * xbee_netdev: Network must be locked when calling sixlowpan_input * sixlowpan: Reassembly buffer can't be freed if provided by radio driver * sixlowpan: Don't free IOB if there is an error processing it as the MAC will try to pass it along to another receiver * ieee802154: Adds basic logging to ieee802154_primitive.c * Minor fixes after rebase * xbee: Adds AT query timeout to retry if XBee doesn't respond to request * same70-xplained: Adds Xbee support. Makes mikroBus slot Kconfig 'choice' * mac802154: Removes unused function declaration * drivers/mrf24j40: Fixes compilation error using . operator rather than -> operator * mac802154_device: Changes a few mac802154_primtive_free's to ieee802154_primitive_free() and changes notif to primitive in a couple places. * mac802154: Adds promiscous mode logic to bypass parsing of incoming frames. MAC char device also checks for promiscous mode and passes whole frames including header and FCS to the application if promiscous mode is enabled. * sixlowpan: Fixes logic to correctly check if packet is large enough to include header. This would cause packets to be considered too small when they are sufficiently sized. * sixlowpan: Fixes forwarding logic to use forwarding device rather than received device to look up destination link layer address * net/ipforward: Fixes typo that caused build error when IP forwarding was enabled with CONFIG_NET_ICMPv6_NEIGHBOR enabled as well. * configs/same70-xplained: Simple spelling fix Approved-by: Gregory Nutt <gnutt@nuttx.org> |
||
|---|---|---|
| .. | ||
| ieee802154_primitive.c | ||
| Kconfig | ||
| mac802154_assoc.c | ||
| mac802154_assoc.h | ||
| mac802154_bind.c | ||
| mac802154_data.c | ||
| mac802154_data.h | ||
| mac802154_device.c | ||
| mac802154_disassoc.c | ||
| mac802154_get_mhrlen.c | ||
| mac802154_getset.c | ||
| mac802154_gts.c | ||
| mac802154_internal.h | ||
| mac802154_ioctl.c | ||
| mac802154_loopback.c | ||
| mac802154_netdev.c | ||
| mac802154_orphan.c | ||
| mac802154_poll.c | ||
| mac802154_poll.h | ||
| mac802154_purge.c | ||
| mac802154_reset.c | ||
| mac802154_rxenable.c | ||
| mac802154_scan.c | ||
| mac802154_scan.h | ||
| mac802154_start.c | ||
| mac802154_sync.c | ||
| mac802154.c | ||
| mac802154.h | ||
| Make.defs | ||
| README.txt | ||
This will eventually hold some general documentation for the IEEE 802.15.4 MAC implementation. NOTE: Throughout the code, excerpts from the standard are quoted as to make the code thoroughly readable. I have tried, to always put a reference [1] and page number. Below is the references that correspond with the reference number [1]