1ad3a22ad5
Gregory Nutt has submitted the SGA and we can migrate the licenses to Apache. Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
69 lines
3.2 KiB
Plaintext
69 lines
3.2 KiB
Plaintext
/****************************************************************************
|
|
* boards/arm/stm32l4/stm32l4r9ai-disco/scripts/memory.ld
|
|
*
|
|
* Licensed to the Apache Software Foundation (ASF) under one or more
|
|
* contributor license agreements. See the NOTICE file distributed with
|
|
* this work for additional information regarding copyright ownership. The
|
|
* ASF licenses this file to you under the Apache License, Version 2.0 (the
|
|
* "License"); you may not use this file except in compliance with the
|
|
* License. You may obtain a copy of the License at
|
|
*
|
|
* http://www.apache.org/licenses/LICENSE-2.0
|
|
*
|
|
* Unless required by applicable law or agreed to in writing, software
|
|
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
|
|
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
|
|
* License for the specific language governing permissions and limitations
|
|
* under the License.
|
|
*
|
|
****************************************************************************/
|
|
|
|
/* The STM32L4R9AI has 2048Kb of FLASH beginning at address 0x0800:0000,
|
|
* 192Kb of SRAM beginning at address 0x2000:0000, and 64Kb of SRAM2 beginning
|
|
* at address 0x1000:0000, and 384Kb of SRAM3 at address 0x2004:0000.
|
|
*
|
|
* The SRAM2 has special properties (e.g. parity check, separate power domain for
|
|
* retention in low power modes, write protection). It is also aliased at address
|
|
* 0x2003:0000 to be contiguous with SRAM1 and SRAM3.
|
|
*
|
|
* When booting from FLASH, FLASH memory is aliased to address 0x0000:0000 where
|
|
* the code expects to begin execution by jumping to the entry point in the
|
|
* 0x0800:0000 address range.
|
|
*
|
|
* For MPU support, the kernel-mode NuttX section is assumed to be 128Kb of
|
|
* FLASH and 16Kb of SRAM. That is an excessive amount for the kernel which
|
|
* should fit into 64KB and, of course, can be optimized as needed (See
|
|
* also boards/arm/stm32l4/stm32l4r9ai-disco/scripts/kernel-space.ld). Allowing the
|
|
* additional does permit addition debug instrumentation to be added to the
|
|
* kernel space without overflowing the partition.
|
|
*
|
|
* Alignment of the user space FLASH partition is also a critical factor:
|
|
* The user space FLASH partition will be spanned with a single region of
|
|
* size 2**n bytes. The alignment of the user-space region must be the same.
|
|
* As a consequence, as the user-space increases in size, the alignment
|
|
* requirement also increases.
|
|
*
|
|
* This alignment requirement means that the largest user space FLASH region
|
|
* you can have will be 512KB at it would have to be positioned at
|
|
* 0x08800000. If you change this address, don't forget to change the
|
|
* CONFIG_NUTTX_USERSPACE configuration setting to match and to modify
|
|
* the check in kernel/userspace.c.
|
|
*/
|
|
|
|
MEMORY
|
|
{
|
|
/* 2048Kb FLASH */
|
|
|
|
kflash (rx) : ORIGIN = 0x08000000, LENGTH = 128K
|
|
uflash (rx) : ORIGIN = 0x08020000, LENGTH = 128K
|
|
xflash (rx) : ORIGIN = 0x08040000, LENGTH = 1792K
|
|
|
|
/* 640Kb of contiguous SRAM */
|
|
|
|
ksram (rwx) : ORIGIN = 0x20000000, LENGTH = 16K
|
|
usram (rwx) : ORIGIN = 0x20004000, LENGTH = 16K
|
|
xsram (rwx) : ORIGIN = 0x20008000, LENGTH = 192K + 64K - 32K
|
|
|
|
sram3 (rwx) : ORIGIN = 0x20040000, LENGTH = 384K
|
|
}
|