nuttx/boards/arm/nrf52/thingy52/include/board.h
raiden00pl 0aa1af7ff1 boards/thingy52: add sx1509 support
SX1509 is used to control various peripherals and RGB LEDs available on the board.
2023-06-27 14:44:00 -03:00

73 lines
2.5 KiB
C

/****************************************************************************
* boards/arm/nrf52/thingy52/include/board.h
*
* Licensed to the Apache Software Foundation (ASF) under one or more
* contributor license agreements. See the NOTICE file distributed with
* this work for additional information regarding copyright ownership. The
* ASF licenses this file to you under the Apache License, Version 2.0 (the
* "License"); you may not use this file except in compliance with the
* License. You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
* License for the specific language governing permissions and limitations
* under the License.
*
****************************************************************************/
#ifndef __BOARDS_ARM_NRF52_THINGY52_INCLUDE_BOARD_H
#define __BOARDS_ARM_NRF52_THINGY52_INCLUDE_BOARD_H
/****************************************************************************
* Included Files
****************************************************************************/
#include <nuttx/config.h>
#include <stdbool.h>
#if defined(CONFIG_ARCH_IRQBUTTONS) && defined(CONFIG_NRF52_GPIOTE)
# include <nuttx/irq.h>
#endif
/****************************************************************************
* Pre-processor Definitions
****************************************************************************/
/* Clocking *****************************************************************/
#define BOARD_SYSTICK_CLOCK (64000000)
/* Button definitions *******************************************************/
/* Board supports four buttons. */
#define BUTTON_BTN1 0
#define NUM_BUTTONS 1
#define BUTTON_BTN1_BIT (1 << BUTTON_BTN1)
/* UART Pins ****************************************************************/
/* UART0:
* RX - P0.02
* TX - P0.03
*/
#define BOARD_UART0_RX_PIN (GPIO_INPUT | GPIO_PORT0 | GPIO_PIN(2))
#define BOARD_UART0_TX_PIN (GPIO_OUTPUT | GPIO_VALUE_ONE | GPIO_PORT0 | GPIO_PIN(3))
/* I2C Pins *****************************************************************/
/* I2C0 (TWI0)
* I2C0_SCL - P0.08
* I2C0_SDA - P0.07
*/
#define BOARD_I2C0_SCL_PIN (GPIO_OUTPUT | GPIO_PORT0 | GPIO_PIN(8))
#define BOARD_I2C0_SDA_PIN (GPIO_INPUT | GPIO_PORT0 | GPIO_PIN(7))
#endif /* __BOARDS_ARM_NRF52_THINGY52_INCLUDE_BOARD_H */