nuttx/boards/arm/stm32/b-g431b-esc1/src/stm32_buttons.c
Xiang Xiao c628529e2d arch/arm: Remove FAR and CODE from board folder(3)
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
2022-05-03 16:50:52 +03:00

112 lines
3.7 KiB
C

/****************************************************************************
* boards/arm/stm32/b-g431b-esc1/src/stm32_buttons.c
*
* Licensed to the Apache Software Foundation (ASF) under one or more
* contributor license agreements. See the NOTICE file distributed with
* this work for additional information regarding copyright ownership. The
* ASF licenses this file to you under the Apache License, Version 2.0 (the
* "License"); you may not use this file except in compliance with the
* License. You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
* License for the specific language governing permissions and limitations
* under the License.
*
****************************************************************************/
/****************************************************************************
* Included Files
****************************************************************************/
#include <nuttx/config.h>
#include <stdint.h>
#include <stdbool.h>
#include <errno.h>
#include <nuttx/board.h>
#include <arch/board/board.h>
#include "stm32.h"
#include "b-g431b-esc1.h"
#ifdef CONFIG_ARCH_BUTTONS
/****************************************************************************
* Public Functions
****************************************************************************/
/****************************************************************************
* Name: board_button_initialize
*
* Description:
* board_button_initialize() must be called to initialize button
* resources. After that, board_buttons() may be called to collect the
* current state of all buttons or board_button_irq() may be called to
* register button interrupt handlers.
*
****************************************************************************/
uint32_t board_button_initialize(void)
{
/* Configure the single button as an input. NOTE that EXTI interrupts are
* also configured for the pin.
*/
stm32_configgpio(GPIO_BTN_USER);
return NUM_BUTTONS;
}
/****************************************************************************
* Name: board_buttons
*
* Description:
* After board_button_initialize() has been called, board_buttons() may be
* called to collect the state of all buttons. board_buttons() returns an
* 32-bit unsigned integer with each bit associated with a button. See the
* BUTTON_*_BIT definitions in board.h for the meaning of each bit.
*
****************************************************************************/
uint32_t board_buttons(void)
{
/* Check the state of the USER button. A LOW value means that the key is
* pressed.
*/
return stm32_gpioread(GPIO_BTN_USER) ? 0 : BUTTON_USER_BIT;
}
/****************************************************************************
* Name: board_button_irq
*
* Description:
* board_button_irq() may be called to register an interrupt handler that
* will be called when a button is depressed or released. The ID value is
* a button enumeration value that uniquely identifies a button resource.
* See the BUTTON_* definitions in board.h for the meaning of the
* enumeration value.
*
****************************************************************************/
#ifdef CONFIG_ARCH_IRQBUTTONS
int board_button_irq(int id, xcpt_t irqhandler, void *arg)
{
int ret = -EINVAL;
if (id == BUTTON_USER)
{
ret = stm32_gpiosetevent(GPIO_BTN_USER, true, true, true, irqhandler,
arg);
}
return ret;
}
#endif
#endif /* CONFIG_ARCH_BUTTONS */