a1c991d921
Move boards to boards folder
* boards: rename configs folder to boards
This is the proposed layout after the change:
boards: - folder containing board folders
<board>: - name of each board
drivers: - extra drivers specific for platform
include: - header files for the boars
scripts: - extra scripts specific for platform
src: - board specific code
tools: - extra tools specific for platform
<config>: - board specific configuration(s)
Note:
<xxx> names are dependent on platform
This is a logical change to aim to the arch layout but this is a
huge change it should be done in several steps to lower the risk.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* Kconfig: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* Makefile: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* Makefile.*: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* Make.defs: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* .sh: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* .mk: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* .c & .h: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
* .bat: replace configs with boards
The change is needed after the path change
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
Approved-by: Gregory Nutt <gnutt@nuttx.org>
|
||
|---|---|---|
| .. | ||
| .gitignore | ||
| defconfig | ||
| ostest.zfpproj | ||
| README.txt | ||
README.txt
^^^^^^^^^^
OSTEST Project
--------------
ostest.zfpproj is a simple ZDS II - ZNEO 5.0.1 project that will allow you
to use the ZDS-II debugger. Before using, copy the following files from
the toplevel directory:
nuttx.hex, nuttx.map, nuttx.lod
to this directory as:
ostest.hex, ostest.map, ostest.lod
Loading and Executing Code
--------------------------
1. Copy the files to this directory as described above
2. Connect the ZiLOG XTools USB debugger.
3. Install the USB driver from the ZDS-II device_drivers directory
4. Start ZDS-II and load the ostest.zfpproj project
5. In the debug tab, connect to the debugger
6. In the debug tab, load code, reset, and go
Hmmm... it appears that the code does not run if started by a hardware reset.
It runs only when started via the debugger. What is up with that?
Console Output
--------------
OS test results will be provided on the serial console at 57600 8N1 baud.
STATUS
------
This exemple works fine when started from ZDS-II. But I have seen problems
when starting from a hardware reset.