101 lines
4.8 KiB
Plaintext
101 lines
4.8 KiB
Plaintext
/****************************************************************************
|
|
* boards/arm/lpc17xx_40xx/lpc4088-devkit/scripts/memory.ld
|
|
*
|
|
* Copyright (C) 2013 Gregory Nutt. All rights reserved.
|
|
* Author: Gregory Nutt <gnutt@nuttx.org>
|
|
*
|
|
* Redistribution and use in source and binary forms, with or without
|
|
* modification, are permitted provided that the following conditions
|
|
* are met:
|
|
*
|
|
* 1. Redistributions of source code must retain the above copyright
|
|
* notice, this list of conditions and the following disclaimer.
|
|
* 2. Redistributions in binary form must reproduce the above copyright
|
|
* notice, this list of conditions and the following disclaimer in
|
|
* the documentation and/or other materials provided with the
|
|
* distribution.
|
|
* 3. Neither the name NuttX nor the names of its contributors may be
|
|
* used to endorse or promote products derived from this software
|
|
* without specific prior written permission.
|
|
*
|
|
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
|
|
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
|
|
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
|
|
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
|
|
* COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
|
|
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
|
|
* BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
|
|
* OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
|
|
* AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
|
|
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN
|
|
* ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
|
|
* POSSIBILITY OF SUCH DAMAGE.
|
|
*
|
|
****************************************************************************/
|
|
|
|
/* The LPC4088 has 512Kb of FLASH beginning at address 0x0000:0000 and
|
|
* 96KB of total SRAM: 64KB of SRAM in the CPU block beginning at address
|
|
* 0x10000000 and 32Kb of Peripheral SRAM in two banks, 8KB at addresses
|
|
* 0x20000000 bank0 first and 8KB at 0x20002000 at bank0 second. And 16KB
|
|
* at 0x20004000 on bank1.
|
|
*
|
|
* For MPU support, the kernel-mode NuttX section is assumed to be 256KB of
|
|
* FLASH and 4KB of SRAM. That, of course, can be optimized as needed (See
|
|
* also boards/arm/lpc17xx_40xx/lpc4088-devkit/scripts/kernel-space.ld);
|
|
* 256KB is probably much more than is needed by the RTOS!
|
|
* That size is selected only because it is available due to alignment
|
|
* issues for the user space FLASH memory.
|
|
*
|
|
* Alignment of the user space FLASH partition is a critical factor: The
|
|
* user space FLASH partition will be spanned with a single region of size
|
|
* 2**n bytes. The alignment of the user-space region must be the same. As
|
|
* a consequence, as the user-space increases in size, the alignmment
|
|
* requirement also increases.
|
|
*
|
|
* This alignment requirement means that the largest user space FLASH region
|
|
* you can have will be 256KB at it would have to be positioned at
|
|
* 0x00400000. If you change this address, don't forget to change the
|
|
* CONFIG_NUTTX_USERSPACE configuration setting to match and to modify
|
|
* the check in kernel/userspace.c.
|
|
*
|
|
* For the same reasons, the maximum size of the SRAM mapping is limited to
|
|
* 4KB. Both of these alignment limitations could be reduced by using
|
|
* multiple regions to map the FLASH/SDRAM range or perhaps with some
|
|
* clever use of subregions.
|
|
*
|
|
* A detailed memory map for the 64KB CPU SRAM region is as follows:
|
|
*
|
|
* 0x10000 0000: Kernel .data region. Typical size: 0.1KB
|
|
* ------- ---- Kernel .bss region. Typical size: 1.8KB
|
|
* 0x10000 0800: Kernel IDLE thread stack (approximate). Size is
|
|
* determined by CONFIG_IDLETHREAD_STACKSIZE and
|
|
* adjustments for alignment. Typical is 1KB.
|
|
* ------- ---- Padded to 4KB
|
|
* 0x10000 1000: User .data region. Size is variable.
|
|
* ------- ---- User .bss region Size is variable.
|
|
* ------- ---- Beginning of kernel heap. Size determined by
|
|
* CONFIG_MM_KERNEL_HEAPSIZE.
|
|
* 0x10000 8000: Beginning of user heap. Can vary with other settings.
|
|
* 0x10001 0000: End+1 of CPU RAM
|
|
*/
|
|
|
|
MEMORY
|
|
{
|
|
/* 256Kb FLASH */
|
|
|
|
kflash (rx) : ORIGIN = 0x00000000, LENGTH = 256K /* More than needed */
|
|
uflash (rx) : ORIGIN = 0x00040000, LENGTH = 256K
|
|
|
|
/* 64Kb of SRAM in the CPU block */
|
|
|
|
ksram (rwx) : ORIGIN = 0x10000000, LENGTH = 4K /* May include waste */
|
|
usram (rwx) : ORIGIN = 0x10001000, LENGTH = 4K
|
|
xsram (rwx) : ORIGIN = 0x10002000, LENGTH = 24K /* All used as heap */
|
|
|
|
/* Other peripheral memory (free, nothing is linked here) */
|
|
|
|
ahbram8_b0a(rwx) : ORIGIN = 0x20000000, LENGTH = 8K
|
|
ahbram8_b0b(rwx) : ORIGIN = 0x20002000, LENGTH = 8K
|
|
ahbram16(rwx) : ORIGIN = 0x20004000, LENGTH = 16K
|
|
}
|