nuttx

1wire

ds28e17.h edited online with Bitbucket

2018-04-05 12:08:56 +00:00

analog

drivers/analog: Add driver for digital to analog converted DAC7571.

2018-08-02 06:40:48 -06:00

audio

Adds loopback test for digital MIC on lc823450 via i2schar driver.

2018-06-05 10:34:22 -06:00

binfmt

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

can

arch/arm/src/samv7: Add ability for CAN BUS_OFF autorecovery according ISO11898-1:2015. With this change we added an ioctl for triggering the autorecovery sequence for BUS_OFF to the CAN-driver and the SAMV7 low-level driver. According the datasheet: If the device goes Bus_Off, it will set MCAN_CCCR.INIT of its own accord, stopping all bus activities. Once MCAN_CCCR.INIT has been cleared by the processor (application), the device will then wait for 129 occurrences of Bus Idle (129 * 11 consecutive recessive bits) before resuming normal operation. At the end of the Bus_Off recovery sequence, the Error Management Counters will be reset. During the waiting time after the resetting of MCAN_CCCR.INIT, each time a sequence of 11 recessive bits has been monitored, a Bit0 Error code is written to MCAN_PSR.LEC, enabling the processor to readily check up whether the CAN bus is stuck at dominant or continuously disturbed and to monitor the Bus_Off recovery sequence. MCAN_ECR.REC is used to count these sequences.

2018-07-04 07:48:59 -06:00

contactless

…

crypto

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

drivers

This commit adds a 1wire subsystem.

2018-04-04 10:57:36 -06:00

eeprom

drivers/eeprobom: EEPROM driver for AT24xx compatible EEPROMs.

2018-02-14 07:53:01 -06:00

fs

include/nuttx/fs/hostfs.h: Update duplicated definitions in HOSTFS that must match NuttX values.

2018-07-09 05:44:48 -06:00

i2c

include/nuttx/i2c/i2c_master.h: Add a definition to distinguish a new START of messages from a repeated start. No lower-half I2C drivers actually implement this new flag bit, however. drivers/i2c/i2c_writeread.c: Use new repeated START definition where appopriated. Other: Some cosmetic changes, updates to README files, etc.

2018-08-03 07:43:57 -06:00

input

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

ioexpander

configs/stm32f103-minimum: Remove nonsensical #error.

2018-01-09 11:17:01 -06:00

lcd

drivers/lcd and configs/olimex-lpc1766stk: Remove support for the Nokia6100 LCD. That LCD uses a 9-bit SPI interface (the 9th bit being the command/data bit that is normally a discrete). That communication was never successfully integrated. I now believe that it would would require some special support from the low-level, MCU SPI driver to manage that 9th bit. The deleted code is still available in the Obsoleted repository in the nuttx/drivers/lcd, nuttx/configs/olimex-lpc1766stk, and Patches directories.

2018-05-19 16:46:21 -06:00

leds

Squashed commit of the following:

2018-07-22 15:13:39 -06:00

lib

libm: Port gamma() and lgamma() from FreeBSD to NuttX.

2017-08-08 07:02:39 -06:00

mm

net/tcp: Re-think CONFIG_NET_TCP_RWND_CONTROL TCP windowing controls.

2018-06-24 14:46:12 -06:00

modem

…

mtd

/include/nuttx/mtd/configdata.h: Fix copy-paste comment in configdata.h

2018-05-08 09:09:47 -06:00

net

Small update to some comments.

2018-07-19 09:09:53 -06:00

nx

Make sure that labeling is used consistently in all function headers (part 3).

2018-02-01 12:17:03 -06:00

power

Merged in raiden00/nuttx (pull request #668 )

2018-07-07 17:04:57 +00:00

sensors

include/nuttx/sensors/bh1750fvi.h: Eliminate a warning.

2018-07-15 07:20:07 -06:00

serial

Squashed commit of the following:

2017-07-28 12:01:05 -06:00

spi

include/nuttx/spi/spi.h: Add a definition for a USBHOST SPI device. drivers/usbhost/usbhost_max3421e.c: Review and correct SPI locking usage.

2018-07-04 08:55:43 -06:00

syslog

syslog: Enable is partial, crippled version of syslog_flush(); arch/: Call syslog_flush() from assertion handling logic.

2018-06-07 16:29:16 -06:00

timers

Update some comments.

2018-07-22 05:56:11 -06:00

usb

arch/arm/include/armv7-m, arch/arm/include/armv7-m, arch/arm/include/stm32f7: Add a configuration to enable workaround for r0p1 Errata 837070: Increasing priority usingwrite to BASEPRI does not take effect immediately.

2018-08-02 16:51:58 -06:00

video

Fix lots of typos in C comments and Kconfig help text

2018-07-08 18:24:45 -06:00

wireless

include/nuttx/wireless/bluetooth: Move Bluetooth header files from include/nuttx/wireless to include/nuttx/wireless/bluetooth for symmetry with other wireless technologies.

2018-04-29 12:43:09 -06:00

.gitignore

…

addrenv.h

…

arch.h

sched/sched: Implements a global scheduler lock capability as part of SMP support. This allows the scheduler to be locked with no knowledge or access to the TCB of the currently running task. This is necessary because accessing the TCB of the currenlty running task is, itself, a non-atomic operation. This global scheduler lock cpability was add just to support that atomic access to the TCB.

2018-02-05 13:12:36 -06:00

ascii.h

…

board.h

This commit eliminates the BOARDIOC_TSCTEST_SETUP command.

2018-01-17 09:33:28 -06:00

cancelpt.h

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

clock.h

Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t

2018-06-16 12:16:13 -06:00

compiler.h

compiler.h: Fix some GCC warnings introduced for SDCC support. Basically a naming collision.

2017-10-02 07:09:31 -06:00

init.h

…

irq.h

spin_lock_irqsave() and spin_unlock_irqrestore() are only valid if the CPU supports global disabling of interrupts.

2018-02-04 15:41:22 -06:00

kmalloc.h

profcs: At file to should user space heap. This replaces the NSH free command.

2017-11-13 12:51:33 -06:00

kthread.h

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

mmcsd.h

…

module.h

…

mqueue.h

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

page.h

…

pgalloc.h

mm/mm_gran: Add a function to get information about the state of the granuale allocator.

2017-11-14 14:41:03 -06:00

poff.h

…

progmem.h

progmem interface: Discern r/w and erase page sizes. Introduce new up_progmem_erasesize architecture API to be able to communicate the read/write page size independently from erase page size. Implement up_progmem_erasesize for all architectures that already support progmem, assuming that for those architectures the sizes of both read/write and erase pages are identical.

2018-05-01 06:23:52 -06:00

pthread.h

…

random.h

Standardization of some function headers.

2018-03-13 09:52:27 -06:00

sched_note.h

…

sched.h

Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t

2018-06-16 12:16:13 -06:00

scsi.h

…

sdio.h

arch/arm/src/lkpc54xx: In SDMMC driver, fix an error which was clobbering the interrupt mask register (xfrmask). Also, add a kludge for the missing DTO interrupt.

2017-12-20 18:39:10 -06:00

semaphore.h

Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t

2018-06-16 12:16:13 -06:00

signal.h

Fix lots of typos in C comments and Kconfig help text

2018-07-08 18:24:45 -06:00

spawn.h

…

spinlock.h

armv7-a, armv7-r, armv7-m: Add atomic read-add-write and read-subtract-write functions.

2018-02-04 12:22:03 -06:00

streams.h

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

symtab.h

…

time.h

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

tls.h

…

tree.h

include/: Remove dangling space at the end of lines.

2017-06-28 13:30:08 -06:00

userspace.h

Make sure that labeling is used consistently in all function headers.

2018-02-01 10:00:02 -06:00

vt100.h

…

wdog.h

Standardization of some function headers.

2018-03-13 09:52:27 -06:00

wqueue.h

Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t

2018-06-16 12:16:13 -06:00

zoneinfo.h

include/: Remove dangling space at the end of lines.

2017-06-28 13:30:08 -06:00