| .. |
|
1wire
|
ds28e17.h edited online with Bitbucket
|
2018-04-05 12:08:56 +00:00 |
|
analog
|
drivers/analog: Add driver for digital to analog converted DAC7571.
|
2018-08-02 06:40:48 -06:00 |
|
audio
|
Adds loopback test for digital MIC on lc823450 via i2schar driver.
|
2018-06-05 10:34:22 -06:00 |
|
binfmt
|
include/nuttx/binfmt/binfmt.h: Remove fields from struct binary_s that are not longer used after commit 20a86dfc1b.
|
2018-08-05 08:50:43 -06:00 |
|
can
|
arch/arm/src/samv7: Add ability for CAN BUS_OFF autorecovery according ISO11898-1:2015. With this change we added an ioctl for triggering the autorecovery sequence for BUS_OFF to the CAN-driver and the SAMV7 low-level driver. According the datasheet: If the device goes Bus_Off, it will set MCAN_CCCR.INIT of its own accord, stopping all bus activities. Once MCAN_CCCR.INIT has been cleared by the processor (application), the device will then wait for 129 occurrences of Bus Idle (129 * 11 consecutive recessive bits) before resuming normal operation. At the end of the Bus_Off recovery sequence, the Error Management Counters will be reset. During the waiting time after the resetting of MCAN_CCCR.INIT, each time a sequence of 11 recessive bits has been monitored, a Bit0 Error code is written to MCAN_PSR.LEC, enabling the processor to readily check up whether the CAN bus is stuck at dominant or continuously disturbed and to monitor the Bus_Off recovery sequence. MCAN_ECR.REC is used to count these sequences.
|
2018-07-04 07:48:59 -06:00 |
|
contactless
|
Add an instance argument to the SPIDEV definitions.
|
2017-04-29 12:26:52 -06:00 |
|
crypto
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
drivers
|
This commit adds a 1wire subsystem.
|
2018-04-04 10:57:36 -06:00 |
|
eeprom
|
drivers/eeprobom: EEPROM driver for AT24xx compatible EEPROMs.
|
2018-02-14 07:53:01 -06:00 |
|
fs
|
include/nuttx/fs/hostfs.h: Update duplicated definitions in HOSTFS that must match NuttX values.
|
2018-07-09 05:44:48 -06:00 |
|
i2c
|
Update some comments
|
2018-08-03 09:30:31 -06:00 |
|
input
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
ioexpander
|
configs/stm32f103-minimum: Remove nonsensical #error.
|
2018-01-09 11:17:01 -06:00 |
|
lcd
|
Remove trailing spaces at the end of lines.
|
2018-08-13 07:39:38 -06:00 |
|
leds
|
Squashed commit of the following:
|
2018-07-22 15:13:39 -06:00 |
|
lib
|
libm: Port gamma() and lgamma() from FreeBSD to NuttX.
|
2017-08-08 07:02:39 -06:00 |
|
mm
|
net/tcp: Re-think CONFIG_NET_TCP_RWND_CONTROL TCP windowing controls.
|
2018-06-24 14:46:12 -06:00 |
|
modem
|
|
|
|
mtd
|
/include/nuttx/mtd/configdata.h: Fix copy-paste comment in configdata.h
|
2018-05-08 09:09:47 -06:00 |
|
net
|
Remove trailing spaces at the end of lines.
|
2018-08-13 07:39:38 -06:00 |
|
nx
|
Make sure that labeling is used consistently in all function headers (part 3).
|
2018-02-01 12:17:03 -06:00 |
|
power
|
Merged in raiden00/nuttx (pull request #668)
|
2018-07-07 17:04:57 +00:00 |
|
sensors
|
Remove trailing spaces at the end of lines.
|
2018-08-13 07:39:38 -06:00 |
|
serial
|
Squashed commit of the following:
|
2017-07-28 12:01:05 -06:00 |
|
spi
|
include/nuttx/spi/spi.h: Add a definition for a USBHOST SPI device. drivers/usbhost/usbhost_max3421e.c: Review and correct SPI locking usage.
|
2018-07-04 08:55:43 -06:00 |
|
syslog
|
syslog: Enable is partial, crippled version of syslog_flush(); arch/: Call syslog_flush() from assertion handling logic.
|
2018-06-07 16:29:16 -06:00 |
|
timers
|
Update some comments.
|
2018-07-22 05:56:11 -06:00 |
|
usb
|
Squashed commit of the following:
|
2018-08-04 16:18:51 -06:00 |
|
video
|
Fix lots of typos in C comments and Kconfig help text
|
2018-07-08 18:24:45 -06:00 |
|
wireless
|
Add missing function names in function headers.
|
2018-08-13 15:53:15 -06:00 |
|
.gitignore
|
|
|
|
addrenv.h
|
|
|
|
arch.h
|
sched/sched: Implements a global scheduler lock capability as part of SMP support. This allows the scheduler to be locked with no knowledge or access to the TCB of the currently running task. This is necessary because accessing the TCB of the currenlty running task is, itself, a non-atomic operation. This global scheduler lock cpability was add just to support that atomic access to the TCB.
|
2018-02-05 13:12:36 -06:00 |
|
ascii.h
|
|
|
|
board.h
|
This commit eliminates the BOARDIOC_TSCTEST_SETUP command.
|
2018-01-17 09:33:28 -06:00 |
|
cancelpt.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
clock.h
|
Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t
|
2018-06-16 12:16:13 -06:00 |
|
compiler.h
|
compiler.h: Fix some GCC warnings introduced for SDCC support. Basically a naming collision.
|
2017-10-02 07:09:31 -06:00 |
|
environ.h
|
fs/proc and sched/environ: Add support for a procfs entry that will permit examining the environment of any task.
|
2018-08-10 10:16:39 -06:00 |
|
init.h
|
|
|
|
irq.h
|
spin_lock_irqsave() and spin_unlock_irqrestore() are only valid if the CPU supports global disabling of interrupts.
|
2018-02-04 15:41:22 -06:00 |
|
kmalloc.h
|
profcs: At file to should user space heap. This replaces the NSH free command.
|
2017-11-13 12:51:33 -06:00 |
|
kthread.h
|
Update some comments. Remove references to non-existent CONFIG_MAX_TASK_ARG.
|
2018-08-08 17:06:46 -06:00 |
|
mmcsd.h
|
|
|
|
module.h
|
|
|
|
mqueue.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
page.h
|
|
|
|
pgalloc.h
|
mm/mm_gran: Add a function to get information about the state of the granuale allocator.
|
2017-11-14 14:41:03 -06:00 |
|
poff.h
|
|
|
|
progmem.h
|
progmem interface: Discern r/w and erase page sizes. Introduce new up_progmem_erasesize architecture API to be able to communicate the read/write page size independently from erase page size. Implement up_progmem_erasesize for all architectures that already support progmem, assuming that for those architectures the sizes of both read/write and erase pages are identical.
|
2018-05-01 06:23:52 -06:00 |
|
pthread.h
|
|
|
|
random.h
|
Standardization of some function headers.
|
2018-03-13 09:52:27 -06:00 |
|
sched_note.h
|
Update ChangeLog in prep for 7.20 release.
|
2017-03-08 10:09:48 -06:00 |
|
sched.h
|
binfmt/ and sched/group: Re-architect the way that loadable ELF or NXFLAT modules are unloaded. Memory resources must be recovered when the task loaded into memory exits. The originmal implementatino used the death-of-child SIGCHLD signal to perform the unload. There are several problems with this: It is overly complex, it requires that the parent task stay resident while the loaded task runs, and it has fatal logic flaws in the protected and kernel model builds because the user signal handler attempts to run in the kernel address space. This commit corrects with using a mindlessly simply BINFMT callback when the task exits.
|
2018-08-05 08:09:54 -06:00 |
|
scsi.h
|
|
|
|
sdio.h
|
drivers/mmcsd/Kconfig: three configuration settings were within ifdef/endif and led to warning: xxx selects xxxx which has unmet direct dependencies. Fix by moving settings to drivers/Kconfig and outside of the ifdef-endif. Also renamed CONFIG_SDIO_PREFLIGHT to CONFIG_ARCH_HAVE_SDIO_PREFLIGHT to follow naming of similar hidden architecture capability configurations.
|
2018-08-05 17:58:17 -06:00 |
|
semaphore.h
|
Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t
|
2018-06-16 12:16:13 -06:00 |
|
signal.h
|
Fix lots of typos in C comments and Kconfig help text
|
2018-07-08 18:24:45 -06:00 |
|
spawn.h
|
|
|
|
spinlock.h
|
armv7-a, armv7-r, armv7-m: Add atomic read-add-write and read-subtract-write functions.
|
2018-02-04 12:22:03 -06:00 |
|
streams.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
symtab.h
|
|
|
|
time.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
tls.h
|
|
|
|
tree.h
|
include/: Remove dangling space at the end of lines.
|
2017-06-28 13:30:08 -06:00 |
|
userspace.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
vt100.h
|
|
|
|
wdog.h
|
Standardization of some function headers.
|
2018-03-13 09:52:27 -06:00 |
|
wqueue.h
|
Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t
|
2018-06-16 12:16:13 -06:00 |
|
zoneinfo.h
|
include/: Remove dangling space at the end of lines.
|
2017-06-28 13:30:08 -06:00 |
