nuttx/boards/arm/nrf52/nrf52-feather
Xiang Xiao 8bcdefafc9 board: Remove -fno-strength-reduce
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
2022-01-19 00:14:03 +01:00
..
configs boards: move USERMAIN_XX out of INIT_ENTRYPOINT 2021-12-24 08:23:30 -06:00
include NuttX: Janne Rosberg: update licenses to Apache 2021-04-10 06:42:19 -05:00
scripts board: Remove -fno-strength-reduce 2022-01-19 00:14:03 +01:00
src Rename CONFIG_LIB_BOARDCTL to CONFIG_BOARDCTL 2021-08-06 13:58:26 +02:00
Kconfig
README.txt drivers/led: Extend userled_set_t from 8bits to 32bits 2020-06-07 19:28:10 +01:00

README
======

README for NuttX port to Adafruit NRF52 Feather boards.

Contents
========

  - Status
  - Feather nRF52 board
  - Configurations

Status
======

  This is the current status of the NRF52 port:

  - The basic OS test configuration and the basic NSH configurations
    are present and fully verified.  This includes:  SYSTICK system time,
    pin and GPIO configuration, and serial console support.

Feather nRF52 board
===================

  https://www.adafruit.com/product/3406

  Console
  -------
  The Feather nRF52 default console is the UART0.

  The Feather nRF52 have USB serial bridge chip on board and UART0 is
  connected to micro USB connector through the bridge chip.

  LEDs
  ----
  The Feather has 2 user-controllable LEDs

    LED   MCU
    LED1  PIN0-17
    LED2  PIN0-19

  A high output illuminates the LED.

  Pushbuttons
  -----------
  The Feather nRF52 does not have user-controllable buttons. The reset button
  on the board is connected to nRF52832 reset pin directly.

Memory Map
==========

  Block                 Start      Length
  Name                  Address
  --------------------- ---------- ------
  FLASH                 0x00000000   512K
  RAM                   0x20000000    64K

Configurations
==============

Each configuration is maintained in a sub-directory and can be selected as
follow:

    tools/configure.sh nrf52-feather:<subdir>

Where <subdir> is one of the following:

  <board>-nsh:
  -----------
    This configuration is the NuttShell (NSH) example at examples/nsh/.

    NOTES:

    1. This configuration uses the mconf-based configuration tool.  To
       change this configurations using that tool, you should:

       a. Build and install the kconfig-mconf tool.  See nuttx/README.txt
          see additional README.txt files in the NuttX tools repository.

       b. Execute 'make menuconfig' in nuttx/ in order to start the
          reconfiguration process.

  CONFIG_ARCH_LEDS
  ----------------
  If CONFIG_ARCH_LEDS is defined, the LED will be controlled as follows
  for NuttX debug functionality (where NC means "No Change").

    TBD!

  If CONFIG_ARCH_LEDS is not defined, then the LEDs are completely under
  control of the application.  The following interfaces are then available
  for application control of the LEDs:

    uint32_t board_userled_initialize(void);
    void board_userled(int led, bool ledon);
    void board_userled_all(uint32_t ledset);