README
======
This directory holds NuttX board support for the Maxim Integrated
MAX32660-EVSYS board. That board features:
o MAX32660 Microcontroller
- Arm Cortex-M4F, 96MHz
- 256KB Flash Memory
- 96KB SRAM
- 16KB Instruction Cache
- Two SPIs
- Two I2Cs
- Two UARTs
- 14 GPIOs
o DIP Breakout Board
- 100mil Pitch Dual Inline Pin Headers
- Breadboard Compatible
o Integrated Peripherals
- Red Indicator LED
- User Pushbutton
o MAX32625PICO-Based Debug Adapter
- CMSIS-DAP SWD Debugger
- Virtual UART Console
Contents
========
o Serial Console
o LEDs and Buttons
Serial Console
==============
A VCOM serial console is available. This is provided by UART1 via pins
P0.10 and P0.11.
LEDs and Buttons
================
LEDs
----
A single red LED is available driven by GPIO P0.13.
This LED is not used by the board port unless CONFIG_ARCH_LEDS is
defined. In that case, the usage by the board port is defined in
include/board.h and src/sam_autoleds.c. The LED is used to encode
OS-related events as follows:
------------------- ----------------------- ------
SYMBOL Meaning LED
------------------- ----------------------- ------
LED_STARTED NuttX has been started OFF
LED_HEAPALLOCATE Heap has been allocated OFF
LED_IRQSENABLED Interrupts enabled OFF
LED_STACKCREATED Idle stack created ON
LED_INIRQ In an interrupt N/C
LED_SIGNAL In a signal handler N/C
LED_ASSERTION An assertion failed N/C
LED_PANIC The system has crashed FLASH
Thus if the LED is statically on, NuttX has successfully booted and is,
apparently, running normally. If the LED is flashing at approximately
2Hz, then a fatal error has been detected and the system has halted.
Buttons
-------
An single button is available on GPIO P0.12 for use by software.
