nuttx/drivers/net/loopback.c

365 lines
10 KiB
C
Raw Normal View History

/****************************************************************************
* drivers/net/loopback.c
*
* Licensed to the Apache Software Foundation (ASF) under one or more
* contributor license agreements. See the NOTICE file distributed with
* this work for additional information regarding copyright ownership. The
* ASF licenses this file to you under the Apache License, Version 2.0 (the
* "License"); you may not use this file except in compliance with the
* License. You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
* WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the
* License for the specific language governing permissions and limitations
* under the License.
*
****************************************************************************/
/****************************************************************************
* Included Files
****************************************************************************/
#include <nuttx/config.h>
#include <stdint.h>
#include <stdbool.h>
#include <time.h>
#include <string.h>
#include <errno.h>
#include <assert.h>
#include <debug.h>
#include <arpa/inet.h>
#include <net/if.h>
#include <nuttx/arch.h>
#include <nuttx/irq.h>
#include <nuttx/wqueue.h>
Network Loopback Driver: A configuration option to control packet size. Historically, the loopback driver used the largest packet size of all enabled link layer protocols. This permitted packets to be forward via the loopbak device with no major loss of performance. However, in experimenting with configurations where no other link layer protocols were enabled, this means the loopback packet size was set to the smallest possible size, to the SLIP minimum of 296 bytes. This resulted in terrible loopback performance. This commit adds an option to increase the loopback packet size with the option CONFIG_NET_LOOPBACK_PACKETSIZE. The loopback driver packet buffer should be quite large. The larger the loopback packet buffer, the better will be TCP performance of the loopback transfers. The Linux loopback device historically used packet buffers of size 16Kb, but that was increased in recent Linux versions to 64Kb. Those sizes may be excessive for resource constrained MCUs, however. The network still enforces the lower limit that is the maximum packet size of all enabled link layer protocols. But this new option permits the loopback packet size to be increased from that. * net/Kconfig: Adds CONFIG_NET_LOOPBACK_PKTSIZE option * include/nuttx/net/netconfig.h: Assures that the packet size that is used is at least as large as the largest packet size of other link layer protocols. * drivers/net/loopback.c: Use that larger packet size. * boards/sim/sim/sim/configs/tcploop/defconfig: Set the loopback packet size to 1500
2020-02-11 01:35:02 +01:00
#include <nuttx/net/netconfig.h>
#include <nuttx/net/netdev.h>
#include <nuttx/net/ip.h>
#include <nuttx/net/loopback.h>
#ifdef CONFIG_NET_PKT
# include <nuttx/net/pkt.h>
#endif
#ifdef CONFIG_NET_LOOPBACK
/****************************************************************************
* Pre-processor Definitions
****************************************************************************/
/* We need to have the work queue to handle interrupts */
#if !defined(CONFIG_SCHED_WORKQUEUE)
# error Worker thread support is required (CONFIG_SCHED_WORKQUEUE)
#endif
/****************************************************************************
* Private Types
****************************************************************************/
/* The lo_driver_s encapsulates all state information for a single hardware
* interface
*/
struct lo_driver_s
{
bool lo_bifup; /* true:ifup false:ifdown */
struct work_s lo_work; /* For deferring poll work to the work queue */
/* This holds the information visible to the NuttX network */
struct net_driver_s lo_dev; /* Interface understood by the network */
};
/****************************************************************************
* Private Data
****************************************************************************/
static struct lo_driver_s g_loopback;
2015-08-26 18:33:44 +02:00
/****************************************************************************
* Private Function Prototypes
****************************************************************************/
/* NuttX callback functions */
static int lo_ifup(FAR struct net_driver_s *dev);
static int lo_ifdown(FAR struct net_driver_s *dev);
static void lo_txavail_work(FAR void *arg);
static int lo_txavail(FAR struct net_driver_s *dev);
#ifdef CONFIG_NET_MCASTGROUP
static int lo_addmac(FAR struct net_driver_s *dev, FAR const uint8_t *mac);
static int lo_rmmac(FAR struct net_driver_s *dev, FAR const uint8_t *mac);
#endif
/****************************************************************************
* Private Functions
****************************************************************************/
/****************************************************************************
* Name: lo_ifup
*
* Description:
* NuttX Callback: Bring up the Ethernet interface when an IP address is
* provided
*
* Input Parameters:
* dev - Reference to the NuttX driver state structure
*
* Returned Value:
* None
*
* Assumptions:
*
****************************************************************************/
static int lo_ifup(FAR struct net_driver_s *dev)
{
FAR struct lo_driver_s *priv = (FAR struct lo_driver_s *)dev->d_private;
#ifdef CONFIG_NET_IPv4
ninfo("Bringing up: %d.%d.%d.%d\n",
(int)(dev->d_ipaddr & 0xff), (int)((dev->d_ipaddr >> 8) & 0xff),
(int)((dev->d_ipaddr >> 16) & 0xff), (int)(dev->d_ipaddr >> 24));
#endif
#ifdef CONFIG_NET_IPv6
ninfo("Bringing up: %04x:%04x:%04x:%04x:%04x:%04x:%04x:%04x\n",
NTOHS(dev->d_ipv6addr[0]), NTOHS(dev->d_ipv6addr[1]),
NTOHS(dev->d_ipv6addr[2]), NTOHS(dev->d_ipv6addr[3]),
NTOHS(dev->d_ipv6addr[4]), NTOHS(dev->d_ipv6addr[5]),
NTOHS(dev->d_ipv6addr[6]), NTOHS(dev->d_ipv6addr[7]));
#endif
priv->lo_bifup = true;
netdev_carrier_on(dev);
return OK;
}
/****************************************************************************
* Name: lo_ifdown
*
* Description:
* NuttX Callback: Stop the interface.
*
* Input Parameters:
* dev - Reference to the NuttX driver state structure
*
* Returned Value:
* None
*
* Assumptions:
*
****************************************************************************/
static int lo_ifdown(FAR struct net_driver_s *dev)
{
FAR struct lo_driver_s *priv = (FAR struct lo_driver_s *)dev->d_private;
netdev_carrier_off(dev);
/* Mark the device "down" */
priv->lo_bifup = false;
return OK;
}
/****************************************************************************
* Name: lo_txavail_work
*
* Description:
* Perform an out-of-cycle poll on the worker thread.
*
* Input Parameters:
* arg - Reference to the NuttX driver state structure (cast to void*)
*
* Returned Value:
* None
*
* Assumptions:
* Called on the higher priority worker thread.
*
****************************************************************************/
static void lo_txavail_work(FAR void *arg)
{
FAR struct lo_driver_s *priv = (FAR struct lo_driver_s *)arg;
/* Ignore the notification if the interface is not yet up */
net_lock();
if (priv->lo_bifup)
{
/* Reuse the devif_loopback() logic, Polling all pending events until
* return stop
*/
while (devif_poll(&priv->lo_dev, NULL));
}
net_unlock();
}
/****************************************************************************
* Name: lo_txavail
*
* Description:
* Driver callback invoked when new TX data is available. This is a
* stimulus perform an out-of-cycle poll and, thereby, reduce the TX
* latency.
*
* Input Parameters:
* dev - Reference to the NuttX driver state structure
*
* Returned Value:
* None
*
* Assumptions:
* Called in normal user mode
*
****************************************************************************/
static int lo_txavail(FAR struct net_driver_s *dev)
{
FAR struct lo_driver_s *priv = (FAR struct lo_driver_s *)dev->d_private;
/* Is our single work structure available? It may not be if there are
* pending interrupt actions and we will have to ignore the Tx
* availability action.
*/
if (work_available(&priv->lo_work))
{
/* Schedule to serialize the poll on the worker thread. */
work_queue(LPWORK, &priv->lo_work, lo_txavail_work, priv, 0);
}
return OK;
}
/****************************************************************************
* Name: lo_addmac
*
* Description:
* NuttX Callback: Add the specified MAC address to the hardware multicast
* address filtering
*
* Input Parameters:
* dev - Reference to the NuttX driver state structure
* mac - The MAC address to be added
*
* Returned Value:
* None
*
* Assumptions:
*
****************************************************************************/
#ifdef CONFIG_NET_MCASTGROUP
static int lo_addmac(FAR struct net_driver_s *dev, FAR const uint8_t *mac)
{
/* There is no multicast support in the loopback driver */
return OK;
}
#endif
/****************************************************************************
* Name: lo_rmmac
*
* Description:
* NuttX Callback: Remove the specified MAC address from the hardware
* multicast address filtering
*
* Input Parameters:
* dev - Reference to the NuttX driver state structure
* mac - The MAC address to be removed
*
* Returned Value:
* None
*
* Assumptions:
*
****************************************************************************/
#ifdef CONFIG_NET_MCASTGROUP
static int lo_rmmac(FAR struct net_driver_s *dev, FAR const uint8_t *mac)
{
/* There is no multicast support in the loopback driver */
return OK;
}
#endif
/****************************************************************************
* Public Functions
****************************************************************************/
/****************************************************************************
* Name: localhost_initialize
*
* Description:
* Initialize the localhost, loopback network driver
*
* Input Parameters:
* None
*
* Returned Value:
* OK on success; Negated errno on failure.
*
****************************************************************************/
int localhost_initialize(void)
{
FAR struct lo_driver_s *priv;
/* Get the interface structure associated with this interface number. */
priv = &g_loopback;
/* Initialize the driver structure */
memset(priv, 0, sizeof(struct lo_driver_s));
2015-08-26 18:33:44 +02:00
priv->lo_dev.d_ifup = lo_ifup; /* I/F up (new IP address) callback */
priv->lo_dev.d_ifdown = lo_ifdown; /* I/F down callback */
priv->lo_dev.d_txavail = lo_txavail; /* New TX data callback */
#ifdef CONFIG_NET_MCASTGROUP
2015-08-26 18:33:44 +02:00
priv->lo_dev.d_addmac = lo_addmac; /* Add multicast MAC address */
priv->lo_dev.d_rmmac = lo_rmmac; /* Remove multicast MAC address */
#endif
priv->lo_dev.d_private = priv; /* Used to recover private state from dev */
/* Register the loopabck device with the OS so that socket IOCTLs can b
* performed.
*/
netdev_register(&priv->lo_dev, NET_LL_LOOPBACK);
/* Set the local loopback IP address */
#ifdef CONFIG_NET_IPv4
net_ipv4addr_copy(priv->lo_dev.d_ipaddr, g_lo_ipv4addr);
net_ipv4addr_copy(priv->lo_dev.d_draddr, g_lo_ipv4addr);
net_ipv4addr_copy(priv->lo_dev.d_netmask, g_lo_ipv4mask);
#endif
#ifdef CONFIG_NET_IPv6
2015-10-04 23:04:00 +02:00
net_ipv6addr_copy(priv->lo_dev.d_ipv6addr, g_lo_ipv6addr);
net_ipv6addr_copy(priv->lo_dev.d_ipv6draddr, g_lo_ipv6addr);
net_ipv6addr_copy(priv->lo_dev.d_ipv6netmask, g_lo_ipv6mask);
#endif
/* Put the network in the UP state */
priv->lo_dev.d_flags = IFF_UP;
return lo_ifup(&priv->lo_dev);
}
#endif /* CONFIG_NET_LOOPBACK */