nuttx/boards/arm/stm32l4/stm32l4r9ai-disco/scripts/memory.ld

84 lines
4.0 KiB
Plaintext
Raw Normal View History

/****************************************************************************
* boards/arm/stm32l4/stm32l4r9ai-disco/scripts/memory.ld
*
* Copyright (C) 2013 Gregory Nutt. All rights reserved.
* Author: Gregory Nutt <gnutt@nuttx.org>
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in
* the documentation and/or other materials provided with the
* distribution.
* 3. Neither the name NuttX nor the names of its contributors may be
* used to endorse or promote products derived from this software
* without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
* COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
* BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
* OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
* AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN
* ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
* POSSIBILITY OF SUCH DAMAGE.
*
****************************************************************************/
/* The STM32L4R9AI has 2048Kb of FLASH beginning at address 0x0800:0000,
* 192Kb of SRAM beginning at address 0x2000:0000, and 64Kb of SRAM2 beginning
* at address 0x1000:0000, and 384Kb of SRAM3 at address 0x2004:0000.
*
* The SRAM2 has special properties (e.g. parity check, separate power domain for
* retention in low power modes, write protection). It is also aliased at address
* 0x2003:0000 to be contiguous with SRAM1 and SRAM3.
*
* When booting from FLASH, FLASH memory is aliased to address 0x0000:0000 where
* the code expects to begin execution by jumping to the entry point in the
* 0x0800:0000 address range.
*
* For MPU support, the kernel-mode NuttX section is assumed to be 128Kb of
* FLASH and 16Kb of SRAM. That is an excessive amount for the kernel which
* should fit into 64KB and, of course, can be optimized as needed (See
* also boards/arm/stm32l4/stm32l4r9ai-disco/scripts/kernel-space.ld). Allowing the
* additional does permit addition debug instrumentation to be added to the
* kernel space without overflowing the partition.
*
* Alignment of the user space FLASH partition is also a critical factor:
* The user space FLASH partition will be spanned with a single region of
* size 2**n bytes. The alignment of the user-space region must be the same.
* As a consequence, as the user-space increases in size, the alignment
* requirement also increases.
*
* This alignment requirement means that the largest user space FLASH region
* you can have will be 512KB at it would have to be positioned at
* 0x08800000. If you change this address, don't forget to change the
* CONFIG_NUTTX_USERSPACE configuration setting to match and to modify
* the check in kernel/userspace.c.
*/
MEMORY
{
/* 2048Kb FLASH */
kflash (rx) : ORIGIN = 0x08000000, LENGTH = 128K
uflash (rx) : ORIGIN = 0x08020000, LENGTH = 128K
xflash (rx) : ORIGIN = 0x08040000, LENGTH = 1792K
/* 640Kb of contiguous SRAM */
ksram (rwx) : ORIGIN = 0x20000000, LENGTH = 16K
usram (rwx) : ORIGIN = 0x20004000, LENGTH = 16K
xsram (rwx) : ORIGIN = 0x20008000, LENGTH = 192K + 64K - 32K
sram3 (rwx) : ORIGIN = 0x20040000, LENGTH = 384K
}