This change reflects that the geometry isn't related to the largest
allocatable unit on the platform.
Calls to read and write block devices are also affected and have
been updated.
Check if all messages were transferred, if not, return -ENXIO.
This is particularly useful when the slave returns an unexpected NAK,
the application code should catch the error to avoid failing silently.
Summary:
- This commit fixes a compile warning if CONFIG_ARCH_INTERRUPTSTACK is set
Impact:
- None
Testing:
- Built with esp32-devkitc:smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- Recently I noticed that ESP32-DevKitC-32D suddenly stops
during receiving ping packets from PC after 10-20mins
- Actually, sometimes memory leak happened when some device
sent a big broadcast packet periodically on the network
- This commit fixes this issue by calling esp_wifi_free_eb()
in the case that the packet exceeds WLAN_BUF_SIZE.
- Also, this commit applies the same logic in the case that
the Wi-Fi interface is down
Impact:
- None
Testing:
- Tested with esp32-devkitc:wapi
Suggested-by: YAMAMOTO Takashi <yamamoto@midokura.com>
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- This commit introduces a driver-specific spinlock to cxd56.c
to improve performance in SMP mode.
Impact:
- cxd56.c in SMP mode only
Testing:
- Tested with nxplayer and nxrecorder with the following configs
- spresense:wifi, spresense:wifi_smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Otherwise, long-sleeping system calls using nxsig_timedwait
are not actually interrupted.
Tested with "ntpcstop" using lm3s6965-ek:qemu-protected config.
Summary:
- Recently I noticed that the nxhello caused hard fault
- Finally, I found that mq_open() had been changed to nxmq_open()
but the calling convention was not correct.
- This commit fixes this issue.
Impact:
- nxmu_server.c only
Testing:
- Tested with nxhello, nxlines & nxdemo with the following configs
- spresense:wifi, spresense:wifi_smp
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
I2C3 not worked due to it's GPIO pin definition has been missing on board.h.
Fix it through include two pin macros on stm32l4x3xx_pinmap.h to board.h.
GPIO_I2C3_SCL and GPIO_I2C3_SDA is pointing A7 and B4 respectively.
1. Don't use the bootloader and partition-table
binaries from a hello-world example. Rather the ESPTOOL_BINDIR variable
can be used to give a user-defined location.
2. The ESPTOOL_BINDIR variable has to be as generic as possible. Don't
assume any board configuration.
Signed-off-by: Abdelatif Guettouche <abdelatif.guettouche@espressif.com>
