Gregory Nutt
db2fe45666
Update some comments
2015-11-20 09:55:18 -06:00
Ken Pettit
d30b73be82
W25: Add support for byte write mode. From Ken Petit
2015-11-20 07:34:07 -06:00
Gregory Nutt
1c86c004c4
FLASH progmem memory MTD: Need to register with PROCFS if enabled
2015-11-19 06:57:02 -06:00
Ken Pettit
7b590ec9a2
drivers/mtd/smart.c Fixed SmartFS wear level error that occurs when the logical sector size is too small to save all wear level status bytes in a single sector. Logical sectors 1 and 2 were simply not being allocated and then the read_sector and write_sector routines were failing. From Ken Petit
2015-11-18 18:12:06 -06:00
Ken Pettit
f0f7dd9956
drivers/mtd/smart.c: Fix a Smart wear-leveling bug. From Ken Petit
2015-11-18 07:01:13 -06:00
Ken Pettit
7e58e4c4cf
W25: Fix W25 page read/write logic
2015-11-18 06:56:53 -06:00
Gregory Nutt
e61d51dab3
If multiple AT24xx devices are supported and resources are allocated, then it may also be necessary to free those resource
2015-11-17 08:39:06 -06:00
Gregory Nutt
724901ceb9
Add support for multiple AT24xx EEPROM devices
2015-11-17 07:40:17 -06:00
Gregory Nutt
015429684f
MTD progmem: Fix an address calculation
2015-11-13 11:32:34 -06:00
Gregory Nutt
2706b4f8aa
mtd_progmem.c: Fix calculation of block size
2015-11-13 09:19:25 -06:00
Gregory Nutt
fdb17620a0
Need a prototype for progmem_initialize in include/nuttx/mtd/mtd.h
2015-11-12 16:03:24 -06:00
Gregory Nutt
ef59f83a38
drivers/mtd/mtd_progmem.c: Add an upper-half driver that can be used with any FLASH library that provides the itnerfaces defined in include/nuttx/progmem.h
2015-11-12 13:40:18 -06:00
Gregory Nutt
9f3edd6373
MTD Smart: Remove checks for 64KB erase block size. erasesize was changed to 32-bits in struct mtd_geometry_s
2015-11-11 08:25:03 -06:00
Gregory Nutt
2ff1b173f2
SmartFS: Backout last change. It alters the behavior when it should not. Obviously there is something that I do not understand
2015-11-11 08:15:08 -06:00
Gregory Nutt
08200d8f86
S24FL1: Fix so that the driver compiles with 512 byte block support
2015-11-10 13:34:33 -06:00
Gregory Nutt
eb1191df63
S24FL1: Fix an error in the page write logic
2015-11-10 12:48:29 -06:00
Gregory Nutt
965addb397
s25fl1: When unprotecting, handle case where protection bits are inverted. Add option to s25flinitilize() to unprotected on power up
2015-11-10 11:33:35 -06:00
Gregory Nutt
2ab0832c26
Smart MTD: fix some outdated logic: geometray erase size is now 32-bits
2015-11-09 09:35:14 -06:00
Gregory Nutt
91429433f6
Correct naming of Spansion part. S25FL1, not ST25FL1
2015-11-07 11:51:09 -06:00
Gregory Nutt
b2bdba0824
S25FL1 FLASH driver: Fix return value from the bwrite() method
2015-11-07 11:26:53 -06:00
Gregory Nutt
bfeef77f1f
SmartFS: Fix a compile error when FS debug enabled. Plus some changes needed by NuttX coding standard
2015-11-05 11:25:39 -06:00
Gregory Nutt
a314b2ac11
ST25FL1: Fix error that was overwriting status
2015-11-05 10:38:47 -06:00
Frank Benkert
e772c56ef6
AT24xx EEPROM Driver: Correct typo from last changeset
2015-10-31 09:04:53 -06:00
Gregory Nutt
46b688e701
Merged in marten_svanfeldt/nuttx-public/for_upstream/at24cxx (pull request #28 )
...
Improvements of AT24xx MTD driver
2015-10-22 18:15:39 +08:00
Marten Svanfeldt
a31d1fd378
Make I2C frequency configurable for the AT24Cxx EEPROM driver
...
Signed-off-by: Marten Svanfeldt <marten@intuitiveaerial.com>
2015-10-21 12:01:36 +08:00
Marten Svanfeldt
af9590eef7
Extend the AT24Cxx MTD driver with support for -04,-08 and -16 parts.
...
These parts utilize the same one-byte-address in the I2C protocol as the -02,
but requires different I2C addresses for different banks of the EEPROM.
Signed-off-by: Marten Svanfeldt <marten@intuitiveaerial.com>
2015-10-21 12:01:36 +08:00
Gregory Nutt
cf14f8d1b5
drivers/: Fixes to spacing and alignement
2015-10-10 10:41:00 -06:00
Gregory Nutt
0b12dbf95d
Fix some spacing problems
2015-10-04 15:04:00 -06:00
Gregory Nutt
cb9e27c3b0
Standardize naming used for public data and function groupings
2015-10-02 16:30:35 -06:00
Gregory Nutt
7d33e858dd
QSPI interface + ST25FL1 driver: Add methods to allocate properly aligned memory
2015-09-06 09:37:34 -06:00
Gregory Nutt
f44320d2a6
ST25FL1: SAMV71 QSPI always does transfers in multiples of 4 bytes
2015-09-02 10:19:47 -06:00
Paul A. Patience
3b89eabd50
Correct #if to #ifdef when the macro can be undefined. Fix bug in AT24XX driver: it should compare AT24XX_ADDRSIZE to 2.
2015-09-01 13:52:29 -04:00
Gregory Nutt
ebd97dcf89
ST25FL1: Make buffers all even multiple of 32-bit values
2015-08-31 10:18:50 -06:00
Gregory Nutt
2d84270552
ST25FL1: Correct some compile problems when file system debug is enabled
2015-08-31 09:25:14 -06:00
Gregory Nutt
ed750f3600
ST25FL1: Changes after review of ST24FL1 clocking
2015-08-29 18:54:20 -06:00
Gregory Nutt
d6b0a8fe72
ST25FL1 driver is code complete
2015-08-29 15:58:54 -06:00
Gregory Nutt
4a1951b192
ST25FL1: Flesh out FLASH write logic
2015-08-28 12:01:08 -06:00
Gregory Nutt
d2653ef7a8
ST25FL1: Update for changes to QSPI interface definitions
2015-08-28 10:15:39 -06:00
Gregory Nutt
361e35a7be
QSPI: Make changes to interface to better work with the SAMV71
2015-08-27 14:16:51 -06:00
Gregory Nutt
7936819fcc
ST25FL1: Flesh out more initialization logic
2015-08-26 14:16:45 -06:00
Gregory Nutt
1cf57ae2bd
Cosmetic
2015-08-26 07:16:07 -06:00
Gregory Nutt
8fe0121e1a
Convert fragmentation ST24FL1 driver to use QSPI interface
2015-08-25 17:20:54 -06:00
Gregory Nutt
94ecf7ebad
drivers/mtd/st25fl1.c: Add a driver for ST25FL1*K QuadSPI FLASH parts
2015-08-25 09:10:12 -06:00
Gregory Nutt
3743d3d84a
Add configuration options for forthcoming st25fl1 devices
2015-08-24 08:00:39 -06:00
David Sidrane
c83d92e846
RAMTRON: Update driver to include support for newer RAMTRON parts.
2015-08-10 11:30:37 -06:00
Gregory Nutt
be09a87c0e
SST25: Eliminate some warnings
2015-07-03 14:38:33 -06:00
Gregory Nutt
342f5fe33d
Fix references to the no-longer-existent misc/ directory in comments, README files, and documentation
2015-06-28 08:08:57 -06:00
Gregory Nutt
d43a09275a
AT24 EEPROM driver. Fix some an incorrect variable name used in conditional compilation. SourceForge patch #55
2015-05-15 06:15:58 -06:00
Gregory Nutt
e4d2822af8
Make some file section headers more consistent with standard
2015-04-08 07:15:32 -06:00
Gregory Nutt
495f420978
Extend the AT24 EEPROM driver so that it supports: (1) the byte-oriented read() method, (2) parts with extended memory regions, and (3) parts with 8-bit addressing.
2015-03-17 14:27:27 -06:00
