Summary:
- Since binding to a local port is not necessary in TCP mode,
it should be done only in UDP mode
Impact:
- None
Testing:
- Tested with NFS server on Ubuntu 18.04 (x86_64)
- Tested with spresense:rndis (defconfig will be updated later)
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- I noticed that receiving a read large packet (e.g. 2KB) in TCP
mode does not work correctly
- Actually, rpcclnt_receive() only received up to MSS
- This commit fixes this issue
Impact:
- TCP mode only
Testing:
- Tested with Ubuntu 18.04 (x86_64)
- Tested with spresense:rndis (defconfig will be updated later)
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
Summary:
- I noticed that NFS over TCP does not work with Ubuntu 18.04
- Finally, I found that the record marking packet should not
be sent separately
- This commit fixes this issue
Impact:
- TCP mode only
Testing:
- Tested with NFS server on Ubuntu 18.04 (x86_64)
- Tested with spresense:rndis (defconfig will be updated later)
Signed-off-by: Masayuki Ishikawa <Masayuki.Ishikawa@jp.sony.com>
to avoid close the same handle twice because
the caller also call elf_uninit in this case
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
Change-Id: Iddcbae9587d11d3b5b06e876d4a037ac0d11992e
since the console is normally opened three time as stdin, stdout and
stderr and remove the dependence on STANDARD_SERIAL because other type
of serial drivers also support the poll through the same codebase.
Signed-off-by: Xiang Xiao <xiaoxiang@xiaomi.com>
Change-Id: Ie68322c4647cc838b295491329969869d6ba310b
elf_init open a elf file , if both enabled
CONFIG_NSH_BUIlTAPPS and CONFIG_NSH_FILE_APPS ,
elf_init will read elf file in /bin directory, but
that length is zero , elf_read failed return and NOT
close elf fd, so this line MUST be return to errout_with_init
This is addressing an issue where Rx interrupts were not restored for
cdcacm after the buffer had been filled (in a burst).
The Rx interrupts were only restored after the watchdog timeout of 200ms
fired.
This happened because CONFIG_SERIAL_RXDMA was set, however, for the
cdcacm driver this does not actually matter as it is relying on
uart_enablerxint to be called via the ops table.
This patch makes sure that uart_enablerxint and uart_disablerxint are
always called, independent of CONFIG_SERIAL_RXDMA, relying on the ops
table to be correct for the case where it should be only a no-op.
Currently Nuttx doesn't seem to be any real support for OTG.
In the future when OTG is supported. This Knob can be removed
and drivers can enable their pin sets based on CONFIG_OTG.
(Adding CONFIG_OTG at this time would be misleading.)
