Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
TX clock or ref clock can be driven either from outside (PHY / oscilator) or by the ENET block.
Typical connection with RMII PHY is that the PHY drives the refclk.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
New configuration IMX9_HAVE_ATF_FIRMWARE introduced,
it is default on and it selects ARM64_HAVE_PSCI, when compiling
bootloader or when using bootloader that does not have atf
this shall be disabled
Signed-off-by: Jouni Ukkonen <jouni.ukkonen@unikie.com>
Using the HLT instruction in VM usually traps into the Hypervisor and releases CPU control. This will result in real-time performance degradation. Using the NOP or MWAIT instruction for an IDLE loop can reduce energy consumption while not trapping into the Hypervisor.
Signed-off-by: ouyangxiangzhen <ouyangxiangzhen@xiaomi.com>
Clean up the interrupt-driven logic in the driver; handle error cases properly,
remove dead code and simplify logic.
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
Change "DMACH_HANDLE *handle" into "DMACH_HANDLE handle". The DMACH_HANDLE is already
defined as "void *".
Signed-off-by: Jukka Laitinen <jukkax@ssrc.tii.ae>
currently esp32 protected mode requires a patched bootloader.
it's a bit cumbersome to build the bootloader for that purpose.
this commit attempts to remove the need of the patched bootloader
by applying the changes by ourselves using esp hal.
64-by-32-bit divisions are prominent in the NuttX, even on 32-bit
machines. Luckily, many of them use a constant divisor that allows
for a much faster multiplication by the divisor's reciprocal.
The compiler already performs this optimization when compiling a 32-by-32
division with a constant divisor. Unfortunately, on 32-bit machines, gcc
does not optimize 64-by-32 divisions in that case, except for constant
divisors that happen to be a power of 2.
Let's avoid the slow path whenever the divisor is constant by manually
computing the reciprocal ourselves and performing the multiplication
inline. In most cases, this improves performance of 64-by-32 divisions
by about two orders of magnitude compared to the __div64_32() fallback,
especially on architectures lacking a native div instruction.
Signed-off-by: ligd <liguiding1@xiaomi.com>
CID 1266677: (#2 of 2): Use 32-bit time_t (Y2K38_SAFETY)
1. declaration_with_small_time_t: Declare use of time_t, which is defined as 32 bits wide on this platform, while the minimum safe width is 64.
Signed-off-by: yinshengkai <yinshengkai@xiaomi.com>
Signed-off-by: ligd <liguiding1@xiaomi.com>
Using the ts/tick conversion functions provided in clock.h
Do this caused we want speed up the time calculation, so change:
clock_time2ticks, clock_ticks2time, clock_timespec_add,
clock_timespec_compare, clock_timespec_subtract... to MACRO
Signed-off-by: ligd <liguiding1@xiaomi.com>
enable debug messages for PCI configuration in qemu-intel64
so we know exactly what happen during execution
Signed-off-by: p-szafonimateusz <p-szafonimateusz@xiaomi.com>
Enforcing the default 48-bit VA for everyone also implies a 4 page table
translation system. However, if less than 40 bits are needed, a full
translation table level can be dropped, making the translations faster.
Thus, make this into a configurable option, instead of enforcing the same
address widht for everyone.
Attempt to service all interrupts pending in the PLIC's claim register. Ideally, this is more efficient than switching context for each interrupt received.
Provides two implementations:
- CSR_CYCLE: Cores which implement hardware performance monitoring.
- CSR_TIME: Uses the machine time registers.
Using the up_perf_xx bindings directory is more efficient than performing a nanosecond conversion on every gettime event.
Most tools used for compliance and SBOM generation use SPDX identifiers
This change brings us a step closer to an easy SBOM generation.
Signed-off-by: Alin Jerpelea <alin.jerpelea@sony.com>
