nuttx

History

cuiziwei 25eb09c3bb nuttx/boards:add KEEP to (.init_array .init_array.) replace (.init_array .init_array.) with KEEP((.init_array .init_array.)). The KEEP statement within a linker script will instruct the linker to keep the specified section, even if no symbols inside it are referenced. This statement is used within the SECTIONS section of the linker script. This becomes relevant when garbage collection is performed at link time, enabled by passing the --gc-sections switch to the linker. The KEEP statement instructs the linker to use the specified section as a root node when creating a dependency graph, looking for unused sections. Essentially forcing the section to be marked as used. Signed-off-by: cuiziwei <cuiziwei@xiaomi.com>		2023-08-05 05:02:25 -07:00
..
configs/nsh
include
scripts	nuttx/boards:add KEEP to (.init_array .init_array.)	2023-08-05 05:02:25 -07:00
src
Kconfig
README.txt

README.txt

README.txt
==========

  This README file discusses the port of NuttX to the Flipper Zero multi-tool
  device. See https://flipperzero.one/ for device details.

Contents
========

  - Device features
  - Status
  - Programming
  - Serial Console
  - Configurations

Device features
===============

  - Multi-protocol wireless STM32WB55RGV6 MCU with 1MiB of Flash and 256KiB of SRAM.
  - USB Type-C connector for communication and charging
  - LiPo battery with charger BQ25896 and fuel gauge BQ27220
  - 5-button joystick and a Back button
  - ST7565 128x64 LCD
  - RGB LED with LP5562 I2C driver
  - Buzzer
  - Vibration motor
  - Micro SD slot connected over SPI
  - CC1101 RF transceiver
  - ST25R3916 high-performance NFC Universal Device and EMVCo reader
  - 125 kHz RFID analog circuit
  - IR led
  - TSOP75538 IR receiver
  - iButton connector
  - GPIO connector with power out and SWD pins

Status
======

  Oct 2022: initial nsh configuration. LCD seems working.

Programming
===========

  The device can be normally flashing and debugging over SWD interface or flashing via
  USB interface when the device is in DFU mode using STMicro's STM32CubeProgrammer. The
  DFU mode will be activated after pressing two round button for 30s. Original firmware
  can be flashed back and stay working until the secure flash area is not changed.

Serial Console
==============

  The MCU's USART1 PB6/PB7 pins are available as external GPIO pins 13/14.

Configurations
==============

  nsh:

    Configures the NuttShell (nsh) located at examples/nsh.  This
    configuration is focused on low level, command-line driver testing.

        nsh> nxhello