| .. |
|
1wire
|
ds28e17.h edited online with Bitbucket
|
2018-04-05 12:08:56 +00:00 |
|
analog
|
drivers/analog: Add driver for digital to analog converted DAC7571.
|
2018-08-02 06:40:48 -06:00 |
|
audio
|
Adds loopback test for digital MIC on lc823450 via i2schar driver.
|
2018-06-05 10:34:22 -06:00 |
|
binfmt
|
binfmt/: Mostly cosmetic changes from review of a previous commit.
|
2018-08-24 06:10:50 -06:00 |
|
can
|
arch/arm/src/samv7: Add ability for CAN BUS_OFF autorecovery according ISO11898-1:2015. With this change we added an ioctl for triggering the autorecovery sequence for BUS_OFF to the CAN-driver and the SAMV7 low-level driver. According the datasheet: If the device goes Bus_Off, it will set MCAN_CCCR.INIT of its own accord, stopping all bus activities. Once MCAN_CCCR.INIT has been cleared by the processor (application), the device will then wait for 129 occurrences of Bus Idle (129 * 11 consecutive recessive bits) before resuming normal operation. At the end of the Bus_Off recovery sequence, the Error Management Counters will be reset. During the waiting time after the resetting of MCAN_CCCR.INIT, each time a sequence of 11 recessive bits has been monitored, a Bit0 Error code is written to MCAN_PSR.LEC, enabling the processor to readily check up whether the CAN bus is stuck at dominant or continuously disturbed and to monitor the Bus_Off recovery sequence. MCAN_ECR.REC is used to count these sequences.
|
2018-07-04 07:48:59 -06:00 |
|
contactless
|
|
|
|
crypto
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
drivers
|
This commit adds a 1wire subsystem.
|
2018-04-04 10:57:36 -06:00 |
|
eeprom
|
drivers/eeprobom: EEPROM driver for AT24xx compatible EEPROMs.
|
2018-02-14 07:53:01 -06:00 |
|
fs
|
include/nuttx/fs/hostfs.h: Update duplicated definitions in HOSTFS that must match NuttX values.
|
2018-07-09 05:44:48 -06:00 |
|
i2c
|
Update some comments
|
2018-08-03 09:30:31 -06:00 |
|
input
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
ioexpander
|
configs/stm32f103-minimum: Remove nonsensical #error.
|
2018-01-09 11:17:01 -06:00 |
|
lcd
|
Remove trailing spaces at the end of lines.
|
2018-08-13 07:39:38 -06:00 |
|
leds
|
Squashed commit of the following:
|
2018-07-22 15:13:39 -06:00 |
|
lib
|
|
|
|
mm
|
mm/: add mm_heapmember function and reimplement kmm_heapmember base on mm_heapmember since this function is very useful if multiple heaps exist.
|
2018-08-23 09:38:49 -06:00 |
|
modem
|
|
|
|
mtd
|
/include/nuttx/mtd/configdata.h: Fix copy-paste comment in configdata.h
|
2018-05-08 09:09:47 -06:00 |
|
net
|
net/netdev: add devif_loopback_out() to check the loopback case where a packet is being sent to itself. Modify the net driver to call this function in this case. This function will simply re-inject the packet back into the network and the network driver will not put anything on the wire.
|
2018-08-24 09:21:33 -06:00 |
|
nx
|
Make sure that labeling is used consistently in all function headers (part 3).
|
2018-02-01 12:17:03 -06:00 |
|
power
|
Merged in raiden00/nuttx (pull request #668)
|
2018-07-07 17:04:57 +00:00 |
|
sensors
|
Remove trailing spaces at the end of lines.
|
2018-08-13 07:39:38 -06:00 |
|
serial
|
|
|
|
spi
|
include/nuttx/spi/spi.h: Add a definition for a USBHOST SPI device. drivers/usbhost/usbhost_max3421e.c: Review and correct SPI locking usage.
|
2018-07-04 08:55:43 -06:00 |
|
syslog
|
syslog: Enable is partial, crippled version of syslog_flush(); arch/: Call syslog_flush() from assertion handling logic.
|
2018-06-07 16:29:16 -06:00 |
|
timers
|
Update some comments.
|
2018-07-22 05:56:11 -06:00 |
|
usb
|
drivers/usbdev/cdcecm.c: Adds USB Device Support for CDC/ECM
|
2018-08-16 08:49:11 -06:00 |
|
video
|
Fix lots of typos in C comments and Kconfig help text
|
2018-07-08 18:24:45 -06:00 |
|
wireless
|
Add missing function names in function headers.
|
2018-08-13 15:53:15 -06:00 |
|
.gitignore
|
|
|
|
addrenv.h
|
|
|
|
arch.h
|
include/nuttx/arch.h: Add architecture-specific prototypes for conversions between physical and virtual address.
|
2018-08-24 08:40:45 -06:00 |
|
ascii.h
|
|
|
|
board.h
|
This commit eliminates the BOARDIOC_TSCTEST_SETUP command.
|
2018-01-17 09:33:28 -06:00 |
|
cancelpt.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
clock.h
|
include/nuttx/clock.h, sched/sched: Support the CPU load measurement using timer_lowerhalf_s interface
|
2018-08-24 10:10:57 -06:00 |
|
compiler.h
|
Squashed commit of the following:
|
2018-08-24 08:30:01 -06:00 |
|
environ.h
|
fs/proc and sched/environ: Add support for a procfs entry that will permit examining the environment of any task.
|
2018-08-10 10:16:39 -06:00 |
|
init.h
|
|
|
|
irq.h
|
spin_lock_irqsave() and spin_unlock_irqrestore() are only valid if the CPU supports global disabling of interrupts.
|
2018-02-04 15:41:22 -06:00 |
|
kmalloc.h
|
Squashed commit of the following:
|
2018-08-24 08:30:01 -06:00 |
|
kthread.h
|
Update some comments. Remove references to non-existent CONFIG_MAX_TASK_ARG.
|
2018-08-08 17:06:46 -06:00 |
|
mmcsd.h
|
|
|
|
module.h
|
|
|
|
mqueue.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
page.h
|
|
|
|
pgalloc.h
|
mm/mm_gran: Add a function to get information about the state of the granuale allocator.
|
2017-11-14 14:41:03 -06:00 |
|
poff.h
|
|
|
|
progmem.h
|
progmem interface: Discern r/w and erase page sizes. Introduce new up_progmem_erasesize architecture API to be able to communicate the read/write page size independently from erase page size. Implement up_progmem_erasesize for all architectures that already support progmem, assuming that for those architectures the sizes of both read/write and erase pages are identical.
|
2018-05-01 06:23:52 -06:00 |
|
pthread.h
|
pthreads: Add support static pthread stack. Add standard pthread_attr_setstack() and pthread_attr_getstack(). In all cases where the stack is released, add check to see which allocator must be used to free the stack: The user or the kernel allocator.
|
2018-08-23 09:49:20 -06:00 |
|
random.h
|
Standardization of some function headers.
|
2018-03-13 09:52:27 -06:00 |
|
sched_note.h
|
|
|
|
sched.h
|
arch/ and task/sched: vfork operation needs to allocate and copy the task argument too. Also correction of the address correction cannot depend on the stack pointer since it is not available in all architectures. Rather callculate the offset from the stack allocation pointer
|
2018-08-24 07:43:00 -06:00 |
|
scsi.h
|
|
|
|
sdio.h
|
drivers/mmcsd/Kconfig: three configuration settings were within ifdef/endif and led to warning: xxx selects xxxx which has unmet direct dependencies. Fix by moving settings to drivers/Kconfig and outside of the ifdef-endif. Also renamed CONFIG_SDIO_PREFLIGHT to CONFIG_ARCH_HAVE_SDIO_PREFLIGHT to follow naming of similar hidden architecture capability configurations.
|
2018-08-05 17:58:17 -06:00 |
|
semaphore.h
|
Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t
|
2018-06-16 12:16:13 -06:00 |
|
signal.h
|
Fix lots of typos in C comments and Kconfig help text
|
2018-07-08 18:24:45 -06:00 |
|
spawn.h
|
|
|
|
spinlock.h
|
armv7-a, armv7-r, armv7-m: Add atomic read-add-write and read-subtract-write functions.
|
2018-02-04 12:22:03 -06:00 |
|
streams.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
symtab.h
|
|
|
|
time.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
tls.h
|
|
|
|
tree.h
|
|
|
|
userspace.h
|
Make sure that labeling is used consistently in all function headers.
|
2018-02-01 10:00:02 -06:00 |
|
vt100.h
|
|
|
|
wdog.h
|
Standardization of some function headers.
|
2018-03-13 09:52:27 -06:00 |
|
wqueue.h
|
Elimate use of the non-standard type systime_t and replace it the equivalent, standard type clock_t
|
2018-06-16 12:16:13 -06:00 |
|
zoneinfo.h
|
|
|
