Gregory Nutt 9f3648d329 sched/: Fix some new coding standard issues. ...

Fix new coding standard issues found by new, revised nxstyle.

2020-03-09 17:31:49 +01:00

..

irq_attach.c

sched/irq: Add support interrupt chains in NuttX. IRQ chain is very useful in these cases: (1) Multiple hardware connect to the same request line(e.g. PCI), (2) Need multiple driver to support one hardware block (like Linux MFD)

2018-08-24 15:10:23 -06:00

irq_chain.c

tools/nxstyle.c: Fix error in conditional logic that was preventing detection bad brace alignment. Add logic to handle alignment of braces in data initializators which following slightly different indentation rules.

2019-06-30 10:35:10 -06:00

irq_csection.c

sched/semaphore/spinlock.c: spin_trylock handle memory barrier and instrumentation correctly.

2019-11-03 19:40:58 -06:00

irq_dispatch.c

Critical Section Monitor (sched/ and fs/procfs: Remove SCHED_IRQMONITOR_GETTIME to simplify the clock source selection: (1) Use up_critmon_gettime if SCHED_IRQMONITOR, (2) Call clock_systimespec if SCHED_TICKLESS, (3) Don't collect timing info for all other cases and move up_critmon_* to arch.h avoid the duplicated declaration.

2019-01-27 10:13:28 -06:00

irq_foreach.c

sched/irq: Add a configuration option to show interrupt information via a procfs file.

2018-01-12 18:26:46 -06:00

irq_initialize.c

Call up_irqinitialize from irq subsystem

2020-02-08 07:39:22 -06:00

irq_procfs.c

sched/: Fix some new coding standard issues.

2020-03-09 17:31:49 +01:00

irq_spinlock.c

Replace all ASSERT with DEBUGASSERT to save the code space

2018-08-24 06:58:30 -06:00

irq_unexpectedisr.c

Fix wait loop and void cast (#24)

2020-01-02 10:54:43 -06:00

irq.h

sched/irq and sched/sched: Measurement of interrupt handler duration used to be available only in Tickless mode since it used the high resolution Tickless timer to measure interrupt time. This commit adds CONFIG_SCHED_IRQMONITOR_GETTIME which, if enabled, will force the interrupt duration caculation to use the same high-resolution, platform-specific timer as is used with the Critical Section Monitor. This leads to two improvements: (1) You can now measure interrupt duration in non-Tickless mode, and (2) in either mode, the interrupt duration and the critical section measures will use the same high-resulotion timer and should, therefore, never be any descripancy due to different clock sources.

2018-11-26 11:29:20 -06:00

Make.defs

sched/irq/Make.defs: Fix warning about irq_csection.o appearing multiple times in the same rule.

2018-11-25 17:22:33 -06:00