nuttx/boards/z16f2800100zcog/ostest/README.txt

40 lines
1.1 KiB
Plaintext
Raw Normal View History

README.txt
^^^^^^^^^^
OSTEST Project
--------------
ostest.zfpproj is a simple ZDS II - ZNEO 5.0.1 project that will allow you
to use the ZDS-II debugger. Before using, copy the following files from
the toplevel directory:
2014-01-01 19:40:18 +01:00
nuttx.hex, nuttx.map, nuttx.lod
2014-01-01 19:40:18 +01:00
to this directory as:
2014-01-01 19:40:18 +01:00
ostest.hex, ostest.map, ostest.lod
Loading and Executing Code
--------------------------
1. Copy the files to this directory as described above
2. Connect the ZiLOG XTools USB debugger.
3. Install the USB driver from the ZDS-II device_drivers directory
4. Start ZDS-II and load the ostest.zfpproj project
5. In the debug tab, connect to the debugger
6. In the debug tab, load code, reset, and go
Hmmm... it appears that the code does not run if started by a hardware reset.
It runs only when started via the debugger. What is up with that?
Console Output
--------------
OS test results will be provided on the serial console at 57600 8N1 baud.
STATUS
------
This exemple works fine when started from ZDS-II. But I have seen problems
when starting from a hardware reset.